Pozor!

Vo Vašom prehliadači nie je aktuálne povolené spúšťanie Javascriptu. Je možné, že niektoré funkcie nebudú fungovať správne. Pre plnú funkčnosť internetového obchodu odporúčame povoliť Javascript. Tu sú inštrukcie ako povoliť JavaScript vo Vašom webovom prehliadači.

Zobrazovaná mena: €

Zobrazenie ceny: bez DPH

NEPLATNÁ ASTM F610/F610M-15 1.3.2015 náhľad

Doplňujúce informácie

ASTM F610/F610M-15

Standard Practice for Evaluating the Quality of Molded Poly(Vinyl Chloride) (PVC) Plastic Pipe Fittings by the Heat Reversion Technique

Automaticky preložený názov:

Štandardná prax pre posúdenie kvality tvarovaných poly ( vinylchloridu ) ( PVC ) , potrubné armatúra z plastu, ktoré Heat Reverzia Technika

NORMA vydaná dňa 1.3.2015

Jazyk
Prevedenie	PDF - okamžité stiahnutie - 74.20 € Tlačené - 74.20 €
Dostupnosť	SKLADOM
Cena	74.20 € bez DPH
74.20 €

Informácie o norme:

Označenie normy: ASTM F610/F610M-15
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.3.2015
Kód tovaru: NS-583779
Počet strán: 5
Približná hmotnosť: 15 g (0.03 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM

Tlač

Odoslať známemu

Otázka

Kategórie - podobné normy:

Trubky z plastické hmoty
Fitinky z plastické hmoty

Anotácia textu normy ASTM F610/F610M-15 :

Keywords:

evaluating, fittings, plastic, PVC, quality ,, ICS Number Code 23.040.20 (Plastic pipes),23.040.45 (Plastic fittings)

Doplňujúce informácie

Significance and Use

3.1 This practice is applicable to distinguish between properly and improperly molded PVC plastic pipe fittings. It can be used to:

3.1.1 Determine whether cold slugs or unfused areas are present (Note 2),

3.1.2 Determine the amount of molded-in stress produced by the molding process (Note 3),

3.1.3 Reveal contamination, and

3.1.4 Show the quality of the weld line.

Note 2: A cold slug is a piece of material that enters the mold at a significantly lower temperature than the rest of the mass.

Note 3: A stress-free part will generally have better properties and higher strength than those with a high degree of stress. Stress-free parts will generally react better when exposed to chemicals.

1. Scope

1.1 This practice covers a procedure for evaluating the quality of molded poly(vinyl chloride) (PVC) plastic pipe fittings after exposure to heat.

1.2 Units—The values stated in either inch-pound or SI units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

Note 1: The values in square brackets are SI units requirements.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.