Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Test Method for Inplane Shear Properties of Hoop Wound Polymer Matrix Composite Cylinders
Automaticky preložený názov:
Štandardná skúšobná metóda pre Inplane šmyk na Hoop rán Polymer Matrix Kompozitné fľaše
NORMA vydaná dňa 15.11.2011
Označenie normy: ASTM D5448/D5448M-11
Poznámka: NEPLATNÁ
Dátum vydania normy: 15.11.2011
Kód tovaru: NS-31231
Počet strán: 13
Približná hmotnosť: 39 g (0.09 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
composite materials, filament winding, inplane shear modulus, inplane shear properites, inplane shear strength, tubes, ICS Number Code 83.120 (Reinforced plastics)
Significance and Use | ||||||||||||||||||||||||||||||||||
This test method is designed to produce inplane shear property data for material specifications, research and development, quality assurance, and structural design and analysis. Factors that influence the inplane shear response and should therefore be reported are material, method of material preparation, specimen preparation, specimen conditioning, environment of testing, specimen alignment and gripping, speed of testing, void content, and fiber volume fraction. Properties, in the test direction, that may be obtained from this test method are as follows: 5.1.1 Inplane Shear Strength, τ12u, 5.1.2 Inplane Shear Strain at Failure, γ12u , and 5.1.3 Inplane Shear Modulus, G12. |
||||||||||||||||||||||||||||||||||
1. Scope | ||||||||||||||||||||||||||||||||||
1.1 This test method determines the inplane shear properties of wound polymer matrix composites reinforced by high-modulus continuous fibers. It describes testing of hoop wound (90°) cylinders in torsion for determination of inplane shear properties. 1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. Within the text the inch-pound units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the test method. 1.3 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||||||||||||||||||||||||||||
2. Referenced Documents | ||||||||||||||||||||||||||||||||||
|
Historická
1.3.2008
Historická
1.5.2008
Historická
1.3.2008
Historická
1.3.2008
Historická
15.4.2009
Historická
1.3.2014
Posledná aktualizácia: 2024-11-22 (Počet položiek: 2 206 568)
© Copyright 2024 NORMSERVIS s.r.o.