Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Test Method for Beam Deflection of “Fiberglass” (Glass-Fiber-Reinforced Thermosetting Resin) Pipe Under Full Bore Flow
Automaticky preložený názov:
Štandardná skúšobná metóda pre Beam vychýlenie & ldquo; sklenených vlákien a rdquo; (Sklenými vláknami vystužený Teplom Živica) potrubia pri plnom Bore Flow
NORMA vydaná dňa 1.8.2014
Označenie normy: ASTM D2925-14
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.8.2014
Kód tovaru: NS-21985
Počet strán: 4
Približná hmotnosť: 12 g (0.03 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
beam deflection, fiberglass pipe, fullbore flow, elastic modulus, ICS Number Code 23.040.20 (Plastic pipes)
Significance and Use | ||||||||||
4.1 In the absence of deflection measurements from actual installed-above-ground piping, this test method may be used to evaluate the influence of span length on mid-span deflections at differing temperatures under full bore flow. Note 3: A flat bearing area, small contact area, and narrow
bearing width may induce high localized support interaction
stresses, and constraints imposed by the supports may also
adversely influence deflections and performance of the
pipe.
|
||||||||||
1. Scope | ||||||||||
1.1 This test method covers measurement of the deflection as a function of time of a specimen of fiberglass pipe supported on a flat non-arced support as a simple beam under full bore flow of water at elevated temperatures. Both glass-fiber-reinforced thermosetting-resin pipe (RTRP) and glass-fiber-reinforced polymer mortar pipe (RPMP) are fiberglass pipes. Note 1: For the purposes of this standard, polymer does not
include natural polymers.
1.2 This test method can be used to determine deflection at varying conditions by substituting other test media. 1.3 Deflections observed using this test method are representative only of piping supported as a simple beam under full bore flow which has one diameter of pipe overhanging at each support. 1.4 The values stated in SI units are to be regarded as the standard. The values given in parentheses are provided for information purposes only. Note 2: There is no known ISO equivalent to this
standard.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||||
2. Referenced Documents | ||||||||||
|
Historická
1.10.2012
Historická
1.12.2011
Historická
1.1.2011
Historická
1.3.2008
Historická
1.2.2013
Historická
1.5.2010
Chcete mať istotu, že používate len platné technické normy?
Ponúkame Vám riešenie, ktoré Vám zaistí mesačný prehľad o aktuálnosti noriem, ktoré používate.
Chcete vedieť viac informácií ? Pozrite sa na túto stránku.
Posledná aktualizácia: 2024-12-23 (Počet položiek: 2 217 157)
© Copyright 2024 NORMSERVIS s.r.o.