Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Test Method for External Pressure Resistance of “Fiberglass” (Glass-Fiber-Reinforced Thermosetting-Resin) Pipe
Automaticky preložený názov:
Štandardná skúšobná metóda pre vonkajšie tlakovej odolnosti & ldquo, CSF-rdquo; (Sklenými vláknami vystužený Teplom-živice) Pipe
NORMA vydaná dňa 1.10.2012
Označenie normy: ASTM D2924-12
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.10.2012
Kód tovaru: NS-21981
Počet strán: 4
Približná hmotnosť: 12 g (0.03 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
external pressure resistance, fiberglass pipe, pipe, reinforced polymer mortar pipe (RPMP), reinforced thermosetting-resin pipe (RTRP), ICS Number Code 23.040.20 (Plastic pipes)
Significance and Use | ||||||||||
5.1 The values obtained by this test method are applicable only to conditions that specifically duplicate the procedures used. 5.2 After a scaling constant is determined for one diameter, this may be used for calculating the external failure pressures of other diameters as long as the resin and reinforcement (if used), the wall thickness-to-diameter ratio, and the reinforcement pattern (if reinforcement is used) are the same. 5.3 In the application of the
following test requirements and recommendations, care must be
exercised to ensure that the specimens tested are truly
representative of the group being studied.
|
||||||||||
1. Scope | ||||||||||
1.1 This test method covers determination of the resistance of fiberglass pipe to external pressure. It classifies failures as buckling, compressive, and leaking. Both glass-fiber-reinforced thermosetting-resin pipe (RTRP) and glass-fiber-reinforced polymer mortar pipe (RPMP) are fiberglass pipes. 1.2 The values stated in inch-pound
units are to be regarded as standard. The SI units given in
parentheses are for information only.
1.3 This standard does not
purport to address all of the safety concerns, if any, associated
with its use. It is the responsibility of the user of this standard
to establish appropriate safety and health practices and determine
the applicability of regulatory limitations prior to use.
|
||||||||||
2. Referenced Documents | ||||||||||
|
Historická
1.3.2014
Historická
1.7.2008
Historická
1.8.2012
Historická
1.8.2013
Historická
15.4.2010
Historická
15.11.2012
Posledná aktualizácia: 2024-11-22 (Počet položiek: 2 206 568)
© Copyright 2024 NORMSERVIS s.r.o.