Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Guide for Insertion of Flexible Polyethylene Pipe Into Existing Sewers
Automaticky preložený názov:
Štandardné Príručka pre vloženie Flexibilné polyetylénovej potrubia do existujúcej kanalizácie
NORMA vydaná dňa 1.8.2013
Označenie normy: ASTM F585-13
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.8.2013
Kód tovaru: NS-55785
Počet strán: 9
Približná hmotnosť: 27 g (0.06 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
conduit, insertion renewal, polyethylene pipe, rehabilitation, sanitary sewer, sliplining, storm sewer, trenchless, ICS Number Code 23.040.20 (Plastic pipes)
Significance and Use | ||||||||||
4.1 The procedures described in this guide are intended as a design and review aid for use by the design engineer in conjunction with manufacturer's recommendations for installing a polyethylene pipe using the insertion method. |
||||||||||
1. Scope | ||||||||||
1.1 This guide describes design and selection considerations and installation procedures for the rehabilitation of sanitary and storm sewers by the insertion of solid wall or profile wall or corrugated polyethylene pipe into an existing pipe and along its existing line and grade. The procedures in this guide are intended to minimize traffic disruption, surface damage, surface restoration and interruption of service. 1.2 The polyethylene piping product manufacturer should be consulted to determine the polyethylene piping product’s suitability for insertion renewal as described in this guide. 1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.4 This standard does not
purport to address all of the safety concerns, if any, associated
with its use. It is the responsibility of the user of this standard
to establish appropriate safety and health practices and determine
the applicability of regulatory limitations prior to use.
PPI Material Handling Guide Standard Practice for Heat Fusion Joining
of Polyethylene Pipe and Fittings (Includes all amendments and
changes 3/17/2022). Standard Practice for Determining
Allowable Tensile Load for Polyethylene (PE) Gas Pipe During
Pull-In Installation Standard Practice for Installation
Acceptance of Plastic Non-pressure Sewer Lines Using Low-Pressure
Air (Includes all amendments and changes 5/13/2020). Standard Terminology Relating to Plastic
Piping Systems |
Historická
1.4.2014
Historická
1.12.2009
Historická
1.8.2011
Historická
1.8.2011
Historická
1.3.2008
Historická
1.8.2013
Posledná aktualizácia: 2024-11-22 (Počet položiek: 2 206 568)
© Copyright 2024 NORMSERVIS s.r.o.