Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Test Method for Evaluating the Quality of Molded Poly(Vinyl Chloride) (PVC) Plastic Pipe Fittings by the Heat Reversion Technique
Automaticky preložený názov:
Štandardná skúšobná metóda pre posudzovanie kvality lisovaných poly (vinylchloridu) (PVC), potrubné armatúra z plastu, ktoré Heat Reverzia Technika
NORMA vydaná dňa 15.4.2010
Označenie normy: ASTM F610/F610M-10
Poznámka: NEPLATNÁ
Dátum vydania normy: 15.4.2010
Kód tovaru: NS-55902
Počet strán: 5
Približná hmotnosť: 15 g (0.03 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
evaluating, fittings, plastic, PVC, quality, Heating tests--plastics, Heat reversion technique, Hydrostatic pressure test, Poly(vinyl chloride) (PVC) fittings, Quality assurance (QA), ICS Number Code 23.040.20 (Plastic pipes), 23.040.45 (Plastic fittings)
Significance and Use |
This test method is applicable to distinguish between properly and improperly molded PVC plastic pipe fittings. It can be used to: Determine whether cold slugs or unfused areas are present (Note 1), Determine the amount of molded-in stress produced by the molding process (Note 2), Reveal contamination, and Show the quality of the weld line. Note 1—A cold slug is a piece of material that enters the mold at a significantly lower temperature than the rest of the mass. Note 2—A stress-free part will generally have better properties and higher strength than those with a high degree of stress. Stress-free parts will generally react better when exposed to chemicals. |
1. Scope |
1.1 This test method covers a procedure for evaluating the quality of molded poly(vinyl chloride) (PVC) plastic pipe fittings after exposure to heat. 1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
Chcete mať istotu, že používate len platné technické normy?
Ponúkame Vám riešenie, ktoré Vám zaistí mesačný prehľad o aktuálnosti noriem, ktoré používate.
Chcete vedieť viac informácií ? Pozrite sa na túto stránku.
Posledná aktualizácia: 2024-12-23 (Počet položiek: 2 217 157)
© Copyright 2024 NORMSERVIS s.r.o.