Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Test Methods for Softening Point of Resins Derived from Pine Chemicals and Hydrocarbons, by Ring-and-Ball Apparatus
Automaticky preložený názov:
Štandardné skúšobné metódy pre bod mäknutia živice odvodené od Pine Chemicals a uhľovodíky, Ring-a-Ball Prístroje
NORMA vydaná dňa 1.7.2014
Označenie normy: ASTM E28-14
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.7.2014
Kód tovaru: NS-46053
Počet strán: 6
Približná hmotnosť: 18 g (0.04 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
polyterpene resins, ring and ball, rosin, softening point, ICS Number Code 87.060.20 (Binders)
Significance and Use | ||||||||
3.1 In general, with materials of these types, softening does not take place at a definite temperature. As the temperature rises, these materials gradually change from brittle or exceedingly thick and slow-flowing materials to softer and less viscous liquids. For this reason, the determination of the softening point must be made by a fixed, arbitrary, and closely defined method if the results obtained are to be comparable. 3.2 In these test methods, the softening point is defined as the temperature at which a disk of the sample held within a horizontal ring is forced downward a distance of 25.4 mm (1 in.) under the weight of a steel ball as the sample is heated at 5°C/min in a water, glycerin, silicone oil, ethylene glycol/water or glycerin/water bath. 3.3 The automatic method was chosen to be the reference method because a round robin demonstrated that it gave more precise results than the manual method. |
||||||||
1. Scope | ||||||||
1.1 These test methods are intended for determining the softening point of resins (including rosin and terpene resins) and similar materials by means of the ring-and-ball apparatus. Note 1: For testing asphalts, tars, and pitches, see Test
Method D36.
1.1.1 Test method using the automated ring and ball softening point apparatus is the reference method and 1.1.2 Test method using the manual ring and ball softening point apparatus is an alternative method. 1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||
2. Referenced Documents | ||||||||
|
Historická
1.10.2010
Historická
15.2.2013
Historická
1.6.2014
Historická
1.9.2013
Historická
1.1.2014
Historická
1.11.2011
Poskytovanie aktuálnych informácií o legislatívnych predpisoch vyhlásených v Zbierke zákonov od roku 1945.
Aktualizácia 2x v mesiaci !
Chcete vedieť viac informácii ? Pozrite sa na túto stránku.
Posledná aktualizácia: 2024-11-04 (Počet položiek: 2 209 323)
© Copyright 2024 NORMSERVIS s.r.o.