Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Specification for Extruded and Compression-Molded Shapes Made from Polyetherimide (PEI)
NORMA vydaná dňa 1.8.2019
Označenie normy: ASTM D7293-19
Dátum vydania normy: 1.8.2019
Kód tovaru: NS-968894
Počet strán: 6
Približná hmotnosť: 18 g (0.04 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
This test method covers requirements and test methods for the material, dimensions, and workmanship, and the properties of extruded and compression-molded sheet, plate, rod and tubular bar manufactured from polyetherimide (PEI) resins. The type of PEI extruded shape shall be categorized by class depending on composition. Every class of PEI shape shall be categorized into one grade for virgin unfilled products. The type and class shall be further differentiated based on dimensional tolerances and dimensional stability (based on elevated temperature excursion testing). Grades 1 and 2 materials are produced with the closest commercial tolerances and lowest stress levels for machined parts. The type, class, and grade is further differentiated based on dimensional stability (elevated temperature excursion test). Tensile strength at break, elongation at break, flexural modulus, izod impact, and tensile modulus (tangent) shall be tested to meet the requirements prescribed. The plate specimens, sheet specimens, rod specimens, and tubular bar specimens shall be tested to meet the requirements prescribed.
PEI, polyetherimide, polyetherimide plates, polyetherimide rod, polyetherimide shapes, polyetherimide tubular bar,, ICS Number Code 83.080.20 (Thermoplastic materials)
1.1 This specification covers requirements and test methods for the dimensions, workmanship, and the properties of extruded and compression-molded sheet, plate, rod and tubular bar manufactured from polyetherimide (PEI) resins.
1.2 The properties included in this specification are those required for the compositions covered. It is possible that other requirements will be necessary to identify particular characteristics important to specialized applications. These shall be specified by using the suffixes as given in Section .
1.3 This specification does not allow for the use of recycled plastics (as defined in Guide ).
1.4 The values stated in English units are regarded as standard in all property and dimensional tables. For reference purposes, SI units are also included in and Table S-PEI.
1.5 The following safety hazards caveat pertains only to the test method or test methods described in this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
Note 1: There is no known ISO equivalent to this standard.
1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
|2. Referenced Documents|
Posledná aktualizácia: 2022-06-28 (Počet položiek: 2 574 040)
© Copyright 2022 NORMSERVIS s.r.o.