Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Test Method for Viscoelastic Properties of Paste Ink Vehicle Using an Oscillatory Rheometer
Automaticky preložený názov:
Štandardná skúšobná metóda pre viskoelastických vlastností Vložiť Ink vozidlo pomocou oscilačný Rheometer
NORMA vydaná dňa 1.6.2012
Označenie normy: ASTM D7271-06(2012)
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.6.2012
Kód tovaru: NS-38050
Počet strán: 3
Približná hmotnosť: 9 g (0.02 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Měření objemu, hmotnosti, hustoty, viskozity
Inkousty. Tiskařské barvy
Keywords:
frequency sweep, G´, G&rdquo,, oscillatory rheometer, printing ink vehicles, rheology, tan delta, viscosity, ICS Number Code 17.060 (Measurement of volume, mass, density, viscosity), 87.080 (Inks. Printing inks)
Significance and Use | ||
5.1 This test method has found acceptance in the lithographic ink industry in predicting rheological behavior of a vehicle under press conditions caused by extrusion, shear-thinning rollers and dot gain recovery. 5.2 This test method is restricted within the torque limitations and strain resolution of the rheometer used. 5.3 Results may not be reproducible if the vehicle is not homogenous. |
||
1. Scope | ||
1.1 This test method covers the procedure for determining the viscoelastic properties of printing ink vehicles by measuring the G', G”, and tan delta using a controlled strain cone and plate oscillatory rheometer. 1.2 This test method provides the flexibility of using several different types of rheometers to determine viscoelastic properties in ink vehicles. 1.3 This test method is not intended for systems that are volatile at procedure temperatures as evaporation may occur effectively changing the percent solids before testing is finished and significantly altering the rheology. 1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||
2. Referenced Documents | ||
|
Historická
1.10.2009
Historická
15.6.2013
Historická
1.12.2011
Historická
1.5.2013
Historická
1.5.2014
Historická
1.11.2013
Posledná aktualizácia: 2024-11-21 (Počet položiek: 2 206 478)
© Copyright 2024 NORMSERVIS s.r.o.