Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Test Method for Coulometric and Volumetric Determination of Moisture in Plastics Using the Karl Fischer Reaction (the Reaction of Iodine with Water)
Automaticky preložený názov:
Štandardná skúšobná metóda pre coulometricky a objemové stanovenie vlhkosti do plastov s použitím Karl Fischer reakcie (reakcií jódu s vodou)
NORMA vydaná dňa 1.9.2011
Označenie normy: ASTM D6869-03(2011)
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.9.2011
Kód tovaru: NS-36824
Počet strán: 4
Približná hmotnosť: 12 g (0.03 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
moisture content, moisture determination, plastics: Coulometry, Iodine reagent method, Karl Fischer reagent method--plastics, Moisture analysis--plastics, Moisture analysis--polymers, Plastics, Sampling plastics/plastic products, Volatile matter content--plastics, Volumetric Karl Fischer analysis, ICS Number Code 83.080.01 (Plastics in general)
Significance and Use | ||
Moisture will affect the processability of some plastics. High moisture content causes surface imperfections (that is, splay or bubbling) or degradation by hydrolysis. Low moisture (with high temperature) causes polymerization. The physical properties of some plastics are affected by the moisture content. |
||
1. Scope | ||
1.1 This method uses the reaction of Iodine (I2) with water (Karl Fischer Reaction) to determine the amount of moisture in a polymer sample. 1.2 This test method is intended to be used for the determination of moisture in most plastics. Plastics containing volatile components such as residual monomers and plasticizers are capable of releasing components that will interfere with the I2/water reaction. 1.3 This method is suitable for measuring moisture over the range of 0.005 to 100 %. Sample size shall be adjusted to obtain an accurate moisture measurement. 1.4 The values stated in SI units are regarded as the standard. Note 1—This standard is technically equivalent to ISO 15512 Method B. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||
2. Referenced Documents | ||
|
Historická
1.4.2010
Historická
1.9.2013
Historická
1.11.2010
Historická
1.6.2013
Historická
15.7.2013
Historická
1.7.2010
Posledná aktualizácia: 2024-11-04 (Počet položiek: 2 209 323)
© Copyright 2024 NORMSERVIS s.r.o.