Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Test Method for Transverse Compressive Properties of Hoop Wound Polymer Matrix Composite Cylinders
Automaticky preložený názov:
Štandardná skúšobná metóda pre priečne Tlačné vlastností Hoop rán Polymer Matrix Kompozitné fľaše
NORMA vydaná dňa 15.11.2011
Označenie normy: ASTM D5449/D5449M-11
Poznámka: NEPLATNÁ
Dátum vydania normy: 15.11.2011
Kód tovaru: NS-31235
Počet strán: 10
Približná hmotnosť: 30 g (0.07 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
composite materials, filament winding, Poisson´s ratio, transverse compressive properties, transverse compressive strength, transverse modulus of elasticity, tubes, ICS Number Code 83.140.20 (Laminated sheets)
Significance and Use | ||||||||||||||||||||||||||||||||||||||
This test method is designed to produce transverse compressive property data for material specifications, research and development, quality assurance, and structural design and analysis. Factors that influence the transverse compressive response and should therefore be reported are: material, method of material preparation, specimen preparation, specimen conditioning, environment of testing, specimen alignment and gripping, speed of testing, void content, and fiber volume fraction. Properties in the test direction that may be obtained from this test method are: 5.1.1 Transverse compressive strength, σ22uc, 5.1.2 Transverse compressive strain at failure, ε22uc, 5.1.3 Transverse compressive modulus of elasticity, E22, and 5.1.4 Poisson’ratio, γ21. |
||||||||||||||||||||||||||||||||||||||
1. Scope | ||||||||||||||||||||||||||||||||||||||
1.1 This test method determines the transverse compressive properties of wound polymer matrix composites reinforced by high-modulus continuous fibers. It describes testing of hoop wound (90) cylinders in axial compression for determination of transverse compressive properties. 1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. Within the text the inch-pound units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the standard. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||||||||||||||||||||||||||||||||
2. Referenced Documents | ||||||||||||||||||||||||||||||||||||||
|
Historická
1.4.2012
Historická
1.5.2007
Historická
1.4.2010
Historická
1.11.2012
Historická
15.5.2014
Historická
15.7.2012
Chcete mať istotu o platnosti využívaných predpisov?
Ponúkame Vám riešenie, aby ste mohli používať stále platné (aktuálne) legislatívne predpisy
Chcete vedieť viac informácií ? Pozrite sa na túto stránku.
Posledná aktualizácia: 2024-12-23 (Počet položiek: 2 217 157)
© Copyright 2024 NORMSERVIS s.r.o.