Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Test Method for Fracture Strength in Cleavage of Adhesives in Bonded Joints
Automaticky preložený názov:
Štandardná skúšobná metóda pre pevnosť v lome pri štiepení lepidiel v lepených spojov
NORMA vydaná dňa 1.5.2012
Označenie normy: ASTM D5041-98(2012)
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.5.2012
Kód tovaru: NS-29606
Počet strán: 5
Približná hmotnosť: 15 g (0.03 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
adhesive, cleavage, fiber-reinforced-plastic, wedge, Adhesive joints, Adhesive bonds, Adhesives, Cleavage testing, Failure end point--adhesives, Fracture testing--adhesive bonds, Joints (adhesives), Strength--adhesives, ICS Number Code 83.180 (Adhesives)
Significance and Use | ||||||||||
This test method provides a means of measuring the cleavage forces and energies required to fail adhesively bonded reinforced flat bonded specimens. It also offers a semi-quantitative observation of failure mode. This test method has found application in screening structural adhesives for bonding reinforced plastics where simple lap shear testing has proven to be inadequate in distinguishing differences between adhesives. It is important to note that the test method measures performance properties of the total bonded system (for example, reinforced plastic and adhesive) but will not yield fundamental properties of the adhesive alone. |
||||||||||
1. Scope | ||||||||||
1.1 This test method covers the determination of fracture strength in cleavage of adhesive bonds when tested on standard reinforced plastic specimens and under specified conditions of preparation and testing (Note 1). Note 1—While this test method is intended for use in reinforced plastic applications, it may be used for measuring fracture properties of adhesives using other plastic adherends, provided consideration is given to the thickness and should be of equal rigidity to the plastic adherends. 1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||||
2. Referenced Documents | ||||||||||
|
Historická
1.3.2014
Historická
1.1.2011
Historická
1.4.2008
Historická
1.10.2013
Historická
1.4.2008
Historická
1.4.2011
Chcete mať istotu, že používate len platné technické normy?
Ponúkame Vám riešenie, ktoré Vám zaistí mesačný prehľad o aktuálnosti noriem, ktoré používate.
Chcete vedieť viac informácií ? Pozrite sa na túto stránku.
Posledná aktualizácia: 2024-11-29 (Počet položiek: 2 209 787)
© Copyright 2024 NORMSERVIS s.r.o.