Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Test Methods for Water Pickup of Lithographic Printing Inks and Vehicles in a Laboratory Mixer (Withdrawn 2020)
Automaticky preložený názov:
Štandardné skúšobné metódy pre zber vody litografických tlačiarenských farieb a technika v laboratóriu Mixer
NORMA vydaná dňa 1.6.2011
Označenie normy: ASTM D4942-11
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.6.2011
Kód tovaru: NS-29225
Počet strán: 4
Približná hmotnosť: 12 g (0.03 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
emulsification, fountain solution, inks, lithographic printing inks, mixers , printing inks, vehicles, water content, water pickup, Gravimetric determination, Ink, Laboratory mixer, Lithographic materials/applications, Printing inks/vehicles, Volumetric measurement, Water analysis, Water pickup, ICS Number Code 87.080 (Inks. Printing inks)
Significance and Use |
The lithographic printing process requires that some dampening solution be emulsified into the ink. These test methods provide a rapid means for determining water pickup under laboratory conditions. Test results may be useful for specification acceptance between the supplier and the customer. In order that results be comparable, the tests must be run at the same temperature and with the same type and quantity of liquid added prior to mixing. The emulsions obtained in these test methods are of larger particle size than those typically produced in printing nips. Because of these and other variables in the printing process, water pickup results do not by themselves predict lithographic printing performance. |
1. Scope |
1.1 These test methods cover two procedures for determining the amount of water picked up by lithographic printing inks in a laboratory mixer. 1.2 Test Method A covers single-point water pickup; Test Method B covers the rate of water pickup. Both test methods are applicable to any printing ink and vehicle intended for the lithographic printing process. 1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
Historická
1.6.2012
Historická
1.6.2011
Historická
1.6.2012
Historická
1.1.2014
Historická
1.12.2010
Historická
1.11.2013
Chcete mať istotu, že používate len platné technické normy?
Ponúkame Vám riešenie, ktoré Vám zaistí mesačný prehľad o aktuálnosti noriem, ktoré používate.
Chcete vedieť viac informácií ? Pozrite sa na túto stránku.
Posledná aktualizácia: 2024-11-22 (Počet položiek: 2 206 568)
© Copyright 2024 NORMSERVIS s.r.o.