Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Guide for Selection of Methods of Particle Size Analysis of Fluvial Sediments (Manual Methods)
Automaticky preložený názov:
Štandardné Príručka pre výber metódy Analýza veľkosti častíc riečnych sedimentov (manuálne metódy)
NORMA vydaná dňa 1.1.2014
Označenie normy: ASTM D4822-88(2014)
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.1.2014
Kód tovaru: NS-28771
Počet strán: 3
Približná hmotnosť: 9 g (0.02 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
particle size, sediment, ICS Number Code 13.060.60 (Examination of water for physical properties)
Significance and Use | ||||||||||
5.1 This guide is general and useful in helping the user to determine an appropriate manual test method for determining the particle size distribution of fluvial sediments. The suggested test methods are not described in this guide, but references are given so that the user may obtain more information about each test method. 5.2 It should be noted that different test methods may and often times do produce different particle size distributions for the same sample. This is due in part to the different test methods requiring native or distilled water, differences in dispersion methods used, and differences in what the test method is measuring, that is, physical or sedimentation diameter. |
||||||||||
1. Scope | ||||||||||
1.1 This guide covers the selection of methods for determining the size distribution of fluvial sediments particles in the range greater than 0.45 μm using manual methods. Manual methods are defined as those methods that require the operator to do some actual measurements and calculations. An automated method would be one which, after the sample is prepared and inserted into an instrument, the instrument (machine) does the measuring and calculations, not the operator. Not all manual methods are presented in this guide. However, where available, at least two methods for each particle size range are given. 1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||||
2. Referenced Documents | ||||||||||
|
Historická
15.6.2013
Historická
1.6.2013
Historická
1.2.2009
Historická
1.5.2011
Historická
15.3.2014
Historická
15.5.2011
Posledná aktualizácia: 2024-11-04 (Počet položiek: 2 209 323)
© Copyright 2024 NORMSERVIS s.r.o.