Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Test Method for Rubber Latex—Styrene-Butadiene Copolymer—Determination of Residual Styrene
Automaticky preložený názov:
Štandardná skúšobná metóda pre latex & ndash, styrén-butadién & ndash; Stanovenie zvyškového styrénu
NORMA vydaná dňa 1.5.2012
Označenie normy: ASTM D4026-06(2012)
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.5.2012
Kód tovaru: NS-25768
Počet strán: 6
Približná hmotnosť: 18 g (0.04 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
styrene, styrene-butadiene rubber (SBR), styrene-butadiene rubber latex, Chemical analysis--rubber chemicals/materials, Gas chromatography (GC)--rubber products/applications, Natural rubber (NR) latex, Residual styrene content, SBR (styrene-butadiene rubber), Styrene content, ICS Number Code 83.040.10 (Latex and raw rubber), 83.060 (Rubber)
Significance and Use | ||||||||
The amount of residual styrene (unreacted styrene) in an SBR latex must be studied from health, safety, economic, and environment viewpoints. This test method is useful in studying these aspects of residual styrene and also in research, development, and factory processing problems. |
||||||||
1. Scope | ||||||||
1.1 This test method covers the determination of the residual styrene content of styrene butadiene (SBR) latex. This test method is based upon direct injection of a diluted latex into a gas chromatograph. The amount of residual styrene is calculated using an internal standard technique. 1.2 The range of residual styrene covered is approximately 100 to 3000 mg/kg (ppm) with a lower detection limit of approximately 50 mg/kg (ppm). 1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. (For specific safety statements, see Section 8.) |
||||||||
2. Referenced Documents | ||||||||
|
Historická
1.6.2010
Historická
1.5.2011
Historická
1.5.2012
Historická
1.7.2009
Historická
1.1.2012
Historická
1.6.2010
Posledná aktualizácia: 2024-12-22 (Počet položiek: 2 217 000)
© Copyright 2024 NORMSERVIS s.r.o.