Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Test Method for Relative Tinting Strength of White Pigments by Reflectance Measurements
Automaticky preložený názov:
Štandardná skúšobná metóda pre relatívnu farbiacu schopnosť bielych pigmentov odrazivosť merania
NORMA vydaná dňa 1.2.2008
Označenie normy: ASTM D2745-00(2008)
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.2.2008
Kód tovaru: NS-21368
Počet strán: 3
Približná hmotnosť: 9 g (0.02 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
muller, tinting strength, white pigments, Instrumental measurement--paints/related coatings/materials, Pigments--white, Reflectance and reflectivity--paints/related coatings/materials, White pigments--general analysis, Pigments (general properties), Scattering coefficient, Tinting strength, Titanium dioxide (TiO2) products, ICS Number Code 87.060.10 (Pigments and extenders)
Significance and Use | ||||
Tinting strength is one of the most important properties of a white pigment. This test method provides a means of testing this property for quality control. This test method is a referee method, and the vehicle for preparing the dispersion and the black for tinting are suggested, but others may be used provided both the purchaser and the seller agree to the changes. The results obtained with a muller do not necessarily agree with industrial situations where different dispersing conditions exist. However, dispersing with a muller is a fast, relatively inexpensive way of testing tinting strength for routine quality control. |
||||
1. Scope | ||||
1.1 This test method describes the procedure for determining the relative tinting strength of white pigments by reflectance measurements of black tints. 1.2 This test method is applicable only for comparing the test pigment with a reference standard of the same type and grade. Note 1—Test Method D 332 describes a procedure for visual assessment of blue-tinted samples. 1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||
2. Referenced Documents | ||||
|
Historická
1.6.2011
Historická
1.6.2011
Historická
1.6.2011
Historická
1.6.2011
Historická
1.11.2012
Historická
1.2.2008
Posledná aktualizácia: 2024-11-04 (Počet položiek: 2 209 323)
© Copyright 2024 NORMSERVIS s.r.o.