Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Test Method for Metal Powder Specific Surface Area by Physical Adsorption
Automaticky preložený názov:
Štandardná skúšobná metóda pre Metal prášok Zvláštne rozlohe o fyzikálnej adsorpcie
NORMA vydaná dňa 1.5.2010
Označenie normy: ASTM B922-10
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.5.2010
Kód tovaru: NS-8804
Počet strán: 4
Približná hmotnosť: 12 g (0.03 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
BET surface area, metal powders, multipoint surface area, outgassing, physical adsorption, refractory metal powders, single point surface area, specific surface area, surface area, BET (Brunauer, Emmett, and Teller) surface area, Metal powders, Multipoint surface area, Outgassing materials/processes, Physical adsorption, Refractory metal powders, Single-point surface area, Specific surface area, Surface analysis--metals/alloys, ICS Number Code 77.160 (Powder metallurgy)
Significance and Use | ||||||
Both suppliers and users of metals can benefit from knowledge of the surface area of these materials. Results of many intermediate and final processing steps are controlled by, or related to, specific surface area of the metal. The performance of many sintered or cast metal structures may be predicted from the specific surface area of the starting metal powder, or all or a portion of the finished piece. |
||||||
1. Scope | ||||||
1.1 This test method covers determination of surface area of metal powders. The test method specifies general procedures that are applicable to many commercial physical adsorption instruments. The method provides specific sample outgassing procedures for listed materials. It includes additional general outgassing instructions for other metals. The multipoint equation of Brunauer, Emmett and Teller (BET), along with the single point approximation of the BET equation, forms the basis for all calculations. 1.2 This test method does not include all existing procedures appropriate for outgassing metallic materials. The procedures included provided acceptable results for samples analyzed during interlaboratory testing. The investigator shall determine the appropriateness of listed procedures. 1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.3.1 State all numerical values in terms of SI units unless specific instrumentation software reports surface area using alternate units. In this case, present both reported and equivalent SI units in the final written report. Many instruments report surface area as m2/g, instead of using correct SI units (m2/kg). 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||
2. Referenced Documents | ||||||
|
Historická
1.4.2009
Historická
1.4.2013
Historická
1.6.2013
Historická
1.10.2008
Historická
1.6.2012
Historická
1.1.2009
Posledná aktualizácia: 2024-12-22 (Počet položiek: 2 217 000)
© Copyright 2024 NORMSERVIS s.r.o.