Cookies
Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
ISO 16063-11:1999
Methods for the calibration of vibration and shock transducers — Part 11: Primary vibration calibration by laser interferometry
Automaticky preložený názov:
Metódy kalibrácie snímačov vibrácií a rázov - Časť 11: Primárne kalibrácia vibráciami pomocou laserovej interferometrie
NORMA vydaná dňa 16.12.1999
Informácie o norme:
Označenie normy: ISO 16063-11:1999
Dátum vydania normy: 16.12.1999
Kód tovaru: NS-426837
Počet strán: 27
Približná hmotnosť: 81 g (0.18 libier)
Krajina: Medzinárodná technická norma
Kategória: Technické normy ISO
Kategórie - podobné normy:
Anotácia textu normy ISO 16063-11:1999 :
Description / Abstract: This part of ISO 16063 specifies the instrumentation and procedure to be used for primary vibration calibration of rectilinear accelerometers (with or without amplifier) to obtain magnitude and phase lag of the complex sensitivity by steady-state sinusoidal vibration and laser interferometry. It is applicable to a frequency range from 1 Hz to 10 kHz and a dynamic range (amplitude) from 0,1 m/s2 to 1 000 m/s2 (frequency-dependent). These ranges are covered with the uncertainty of measurement specified in clause 2. Calibration frequencies lower than 1 Hz (e.g. 0,4 Hz, which is a reference frequency used in other International Standards) and acceleration amplitudes smaller than 0,1 m/s2 (e.g. 0,004 m/s2 at 1 Hz) can be achieved using Method 3 specified in this part of ISO 16063, in conjunction with an appropriate low-frequency vibration generator. Method 1 (fringe-counting method) is applicable to sensitivity magnitude calibration in the frequency range 1 Hz to 800 Hz and, under special conditions, at higher frequencies (cf. clause 7). Method 2 (minimum-point method) can be used for sensitivity magnitude calibration in the frequency range 800 Hz to 10 kHz (cf. clause 8). Method 3 (sine-approximation method) can be used for magnitude of sensitivity and phase calibration in the frequency range 1 Hz to 10 kHz (cf. clause 9). Methods 1 and 3 provide for calibrations at fixed acceleration amplitudes at various frequencies. Method 2 requires calibrations at fixed displacement amplitudes (acceleration amplitude varies with frequency).
Doporučujeme:
