ČSN EN 15502-1+A1 (075316)

Kotle na plynná paliva pro ústřední vytápění - Část 1: Obecné požadavky a zkoušky (Norma k přímému použití jako ČSN).



NORMA vydaná dňa 1.6.2024


Jazyk
Prevedenie
DostupnosťSKLADOM
Cena47.90 bez DPH
47.90

Informácie o norme:

Označenie normy: ČSN EN 15502-1+A1
Rozlišovací znak: 075316
Katalógové číslo: 519135
Dátum vydania normy: 1.6.2024
Kód tovaru: NS-1186135
Počet strán: 216
Približná hmotnosť: 679 g (1.50 libier)
Krajina: Česká technická norma
Kategória: Technické normy ČSN

Kategórie - podobné normy:

Bojlery a výměníky tepla
Ústřední topení

Anotácia textu normy ČSN EN 15502-1+A1 (075316):

A1

This document specifies the common requirements and test methods, as well as the classification, marking and energy labelling of gas-fired central heating boilers that are fitted with atmospheric burners, fan assisted atmospheric burners or fully premixed burners, and are hereafter referred to as "boilers".

This document is to be used in conjunction with the specific Parts 2 (Part 2-1, Part 2-2 and following ones).

This document applies to boilers of types B and C:

NOTE - For further background information on appliance types see EN 1749:2020.

a) that use one or more combustible gases of the three gas families at the pressures stated in EN 437:2021;

b) where the temperature of the water does not exceed 105 °C during normal operation;

c) where the maximum operating pressure in the water circuit does not exceed 6 bar;

d) which can give rise to condensation under certain circumstances;

e) which are declared in the instructions for installation to be either a "condensing" boiler or a "low temperature boiler" or a "standard boiler" or an "other boiler". If no declaration is given the boiler is to be considered both a "standard boiler" and an "other boiler";

f) which are intended to be installed inside a building or in a partially protected place;

g) which are intended to produce also hot water either by the instantaneous or storage principle as a single unit.

This document applies to boilers designed for sealed water systems or for open water systems.

NOTE - This general standard and the specific standards (see Part 2) provide requirements for boilers with known constructions. For boilers with any alternative constructions, which might not fully be covered by this standard or a specific standard, the risk associated with this alternative construction will need to be assessed.

An example of an assessment methodology, based upon risk assessment, is given in Clause 11.

This document is not intended to cover appliances intended for connection to gas grids where the quality of the distributed gas is likely to vary to a large extent over the lifetime of the appliance (see Annex AB).

This document does not cover all the requirements for :

  • aa) appliances above 1000 kW;
  • ab) appliances designed and constructed to burn gas containing carbon monoxide or other toxic components;
  • ac) appliance having a supplementary heater

Doporučujeme:




Cookies Cookies

Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.

Súhlas môžete odmietnuť tu.

Tu máte možnosť prispôsobiť si nastavenia súborov cookies v súlade s vlastnými preferenciami.

Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov.