Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Test Method for Corrosion Testing of Products of Zirconium, Hafnium, and Their Alloys in Water at 680°F (360°C) or in Steam at 750°F (400°C) (Includes all amendments And changes 2/28/2019).
Automaticky preložený názov:
Štandardná skúšobná metóda pre koróznej skúške nomenklatúre zirkónu, hafnia a ich zliatin vo vode pri 680 ° F (360 ° C) alebo v pare pri 750 ° F (400 ° C)
NORMA vydaná dňa 1.9.2011
Označenie normy: ASTM G2/G2M-06(2011)e1
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.9.2011
Kód tovaru: NS-57588
Počet strán: 8
Približná hmotnosť: 24 g (0.05 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
mass gain, steam corrosion, water corrosion, ICS Number Code 77.060 (Corrosion of metals), 77.120.99 (Other non-ferrous metals and their alloys)
Significance and Use | ||||
This test method is primarily used as an acceptance test for products of zirconium, hafnium, and their alloys. This standard has been widely used in the development of new alloys, heat treating practices, and for evaluation of welding techniques. Specimens are normally tested after careful etching and rinsing. Specimens with as-manufactured surfaces may also be tested without further surface removal. When tubing with a second material clad on the inner surface is to be tested, the inner cladding shall be removed prior to the test. |
||||
1. Scope | ||||
1.1 This test method covers (1) the determination of mass gain, and (2) the surface inspection of products of zirconium, hafnium, and their alloys when corrosion tested in water at 680°F [360°C] or in steam at 750°F [400°C]. 1.2 This test method is to be utilized in its entirety to the extent specified herein as a product acceptance test. 1.3 This test method may be used on wrought products, castings, powder metallurgy products, and weld metals. 1.4 Unless a single unit is used, for example corrosion mass gain in mg/dm2, the values stated in either inch-pound or SI units are to be regarded separately as standard. The values stated in each system are not exact equivalents; therefore each system must be used independently of the other. SI values cannot be mixed with inch-pound values. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific precautionary statements, see Section 9. |
||||
2. Referenced Documents | ||||
|
Historická
1.5.2012
Historická
1.5.2012
Historická
1.5.2012
Historická
1.5.2012
Historická
1.5.2013
Historická
1.10.2010
Posledná aktualizácia: 2024-12-23 (Počet položiek: 2 217 157)
© Copyright 2024 NORMSERVIS s.r.o.