Cookies
Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
ASTM G19-88(1996)e1
Standard Test Method for Disbonding Characteristics of Pipeline Coatings by Direct Soil Burial (Includes all amendments And changes 8/16/2017).
Automaticky preložený názov:
Štandardná skúšobná metóda pre Disbonding Charakteristika potrubia Coatings priamym pôdy Pohreb
NORMA vydaná dňa 10.6.1996
Informácie o norme:
Označenie normy: ASTM G19-88(1996)e1
Poznámka: NEPLATNÁ
Dátum vydania normy: 10.6.1996
Kód tovaru: NS-57570
Počet strán: 4
Približná hmotnosť: 12 g (0.03 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Anotácia textu normy ASTM G19-88(1996)e1 :
Keywords:
Coating thickness, Current measurement, Disbonding, Electrical measurements-coating applications, Holiday detection, Micrometer, Nonmetallic materials, Pipeline coatings, Soil burial test, disbonding characteristics of pipeline coatings, by direct soil burial,, test, ICS Number Code 87.040 (Paints and varnishes)
Doplňujúce informácie
| 1. Scope | ||||
|
1.1 This test method describes the determination of the relative disbonding characteristics of damaged coatings on steel pipe by cathodic protection potentials in direct soil burial. This test method is intended to apply to the testing of all types of nonmetallic pipeline coatings and tapes including thermoplastics, thermoset, and bituminous materials. 1.2 Results may vary widely when test sites are in different geographical areas of the country, and even in different localities. 1.3 This test method is limited to nonconducting, or nonmetallic pipe coatings and is not applicable to conducting materials such as zinc coatings on steel pipe. 1.4 This test method may involve hazardous operations and equipment. This test method does not purport to address all of the safety problems associated with its use. It is the responsibility of the user of this test method to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. 1.5 The values stated in SI units to three significant decimals are to be regarded as the standard. |
||||
| 2. Referenced Documents | ||||
|
Odporúčame:
Aktualizácia technických noriem
Chcete mať istotu, že používate len platné technické normy?
Ponúkame Vám riešenie, ktoré Vám zaistí mesačný prehľad o aktuálnosti noriem, ktoré používate.
Chcete vedieť viac informácií ? Pozrite sa na túto stránku.
