Cookies
Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
ASTM F674-92(1999)
Standard Practice for Preparing Silicon for Spreading Resistance Measurements (Withdrawn 2003)
Automaticky preložený názov:
Štandardná prax pre prípravu Silicon pre šírenie Meranie odporu ( Withdrawn 2003 )
NORMA vydaná dňa 1.1.1999
Informácie o norme:
Označenie normy: ASTM F674-92(1999)
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.1.1999
Kód tovaru: NS-56072
Počet strán: 4
Približná hmotnosť: 12 g (0.03 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Anotácia textu normy ASTM F674-92(1999) :
Keywords:
Electrical conductors-semiconductors, silicon (high-resistivity, -type), preparing specimens for spreading, resistance measurement, practice,, Probe methods-spreading resistance probe, preparing high-resistivity -type silicon specimens, practice,, Resistance and resistivity (electrical)-semiconductors, preparing high-resistivity -type silicon specimens (for spreading, resistance measurement), practice,, Silicon-semiconductor applications
Doplňujúce informácie
| 1. Scope |
|
This standard was transferred to SEMI (www.semi.org) May 2003 1.1 This practice covers the surface preparation of silicon samples prior to measurement of resistivity variations by the spreading resistance technique. 1.2 Separate procedures are given for preparation of large-area specimens for measurement of lateral resistivity variations and for preparation of bevel-sectioned specimens (usually small chips) for measurement of vertical variations of resistivity (depth profiling). Note 1-Benefits derived from diamond polishing are ( ) stability and reproducibility of spreading resistance values on large area or beveled specimens, and ( ) acuity of beveled surface geometry. The benefits of stability and reproducibility are likely to apply to both conductivity types and all resistivity values; however, they have been demonstrated extensively only for (111) -type above 1 [omega][dot]cm. Enhanced bevel acuity is independent of conductivity-type or resistivity value.1.3 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
Odporúčame:
Aktualizácia technických noriem
Chcete mať istotu, že používate len platné technické normy?
Ponúkame Vám riešenie, ktoré Vám zaistí mesačný prehľad o aktuálnosti noriem, ktoré používate.
Chcete vedieť viac informácií ? Pozrite sa na túto stránku.
