Cookies
Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
ASTM F610/F610M-21
Standard Practice for Evaluating the Quality of Molded Poly(Vinyl Chloride) (PVC) Plastic Pipe Fittings by the Heat Reversion Technique
NORMA vydaná dňa 1.4.2021
Informácie o norme:
Označenie normy: ASTM F610/F610M-21
Dátum vydania normy: 1.4.2021
Kód tovaru: NS-1023017
Počet strán: 5
Približná hmotnosť: 15 g (0.03 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Kategórie - podobné normy:
Anotácia textu normy ASTM F610/F610M-21 :
Keywords:
evaluating, fittings, plastic, PVC, quality,, ICS Number Code 23.040.20 (Plastic pipes),23.040.45 (Plastic fittings)
Doplňujúce informácie
| Significance and Use |
|
3.1?This practice is applicable to distinguish between properly and improperly molded PVC plastic pipe fittings. It can be used to: 3.1.1?Determine whether cold slugs or unfused areas are present (Note 2), 3.1.2?Determine the amount of molded-in stress produced by the molding process (Note 3), 3.1.3?Reveal contamination, and 3.1.4?Show the quality of the weld line. Note 2:?A cold slug is a piece of material that enters the
mold at a significantly lower temperature than the rest of the
mass.
Note 3:?A stress-free part will generally have better
properties and higher strength than those with a high degree of
stress. Stress-free parts will generally react better when exposed
to chemicals.
|
| 1. Scope |
|
1.1?This practice covers a procedure for evaluating the quality of molded poly(vinyl chloride) (PVC) plastic pipe fittings after exposure to heat. 1.2?UnitsThe values stated in either inch-pound or SI units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. Note 1:?The values in square brackets are SI units
requirements.
1.3?This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
Odporúčame:
Aktualizácia technických noriem
Chcete mať istotu, že používate len platné technické normy?
Ponúkame Vám riešenie, ktoré Vám zaistí mesačný prehľad o aktuálnosti noriem, ktoré používate.
Chcete vedieť viac informácií ? Pozrite sa na túto stránku.
