Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Test Methods for Determining the Mechanical Properties of Externally and Internally Threaded Fasteners, Washers, Direct Tension Indicators, and Rivets (Includes all amendments And changes 9/26/2016).
Automaticky preložený názov:
Štandardné testovacie metódy pre stanovenie mechanických vlastností externe , tak interne závitových spojov , podložky , Direct napínacie ukazovateľov , a nity
NORMA vydaná dňa 1.11.2014
Označenie normy: ASTM F606/F606M-14a
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.11.2014
Kód tovaru: NS-584391
Počet strán: 19
Približná hmotnosť: 57 g (0.13 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
compression load, hardness, proof load, properties, tensile, testing, yield,, ICS Number Code 21.060.01 (Fasteners in general)
1. Scope | ||||||||||||||||||||||||||||||||||||||||||||||||||||
1.1 These test methods cover establishment of procedures for conducting tests to determine the mechanical properties of externally and internally threaded fasteners, washers, direct tension indicators, and rivets. 1.2 Property requirements and the applicable tests for their determination are specified in individual product standards. In those instances where the testing requirements are unique or at variance with these standard procedures, the product standard shall specify the controlling testing requirements. In the absence of any specified test requirement(s), these test methods shall apply. 1.3 These test methods describe mechanical tests for determining the following properties:
1.4 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. Note 1: The values are stated in inch-pound for inch fasteners
and SI metric units for metric fasteners.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||||||||||||||||||||||||||||||||||||||||||||||
2. Referenced Documents | ||||||||||||||||||||||||||||||||||||||||||||||||||||
|
Historická
15.11.2014
Historická
1.5.2014
Historická
1.5.2012
Historická
1.5.2012
Historická
1.10.2014
Historická
1.5.2014
Posledná aktualizácia: 2025-05-01 (Počet položiek: 2 198 088)
© Copyright 2025 NORMSERVIS s.r.o.