Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Specification for Nonferrous Bolts, Hex Cap Screws, and Studs for General Use (Metric)
Automaticky preložený názov:
Štandardné špecifikácie pre neželezných skrutky, Hex Cap skrutky, a skrutky pre všeobecné použitie (metrické)
NORMA vydaná dňa 1.4.2012
Označenie normy: ASTM F468M-06(2012)
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.4.2012
Kód tovaru: NS-55433
Počet strán: 11
Približná hmotnosť: 33 g (0.07 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
bolts, cap screws, general use, nonferrous, studs , Aluminum alloys--specifications, Copper, Copper alloy--specifications, Fasteners (metal)--specifications, Naval brass, Nickel alloy bolting materials--specifications, Nickel-copper alloy--specifications, Nickel-copper-aluminum alloys, Nickel-molybdenum alloys--specifications, Nickel-molybdenum-chromium alloys--specifications, Nonferrous bolting materials, Palladium (titanium plus palladium)--specifications
Significance and Use | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||
For purposes of determining compliance with the specified limits for requirements of the properties listed in this specification, an observed value or calculated value shall be rounded in accordance with Practice E29. |
||||||||||||||||||||||||||||||||||||||||||||||||||||||||
1. Scope | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||
1.1 This specification covers the requirements for commercial wrought nonferrous bolts, hex cap screws, and studs in nominal thread diameters M6 to M36 inclusive manufactured from a number of alloys in common use and intended for general service applications. 1.2 Unless otherwise specified, nuts used on these bolts, cap screws, and studs shall conform to the requirements of Specification F467M. Nuts shall be of the same alloy group as the fastener on which they are used and shall have a specified minimum proof stress equal to or greater than the specified minimum tensile strength stress of the fastener on which they are used. 1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. Note 1—This specification is the metric companion of Specification F468. |
||||||||||||||||||||||||||||||||||||||||||||||||||||||||
2. Referenced Documents | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||
|
Historická
1.12.2011
Historická
1.3.2014
Historická
1.12.2007
Historická
1.11.2009
Historická
1.4.2012
Historická
1.5.2009
Posledná aktualizácia: 2024-12-22 (Počet položiek: 2 217 000)
© Copyright 2024 NORMSERVIS s.r.o.