ASTM F3634-23

4.1?A standard procedure is necessary to prepare samples of oils or petroleum products at different oil weathering stages with compositional distribution that is representative of weathered spilled oil.

4.2?This procedure uses standardized equipment and test procedures.

4.3?This procedure should be performed at the stages of weathering corresponding to the spill conditions of interest.

1.1?This guide summarizes methods to produce representative residual oil following evaporative weathering using a rotary evaporator.

1.2?This guide covers general procedures for artificial weathering of oil by using rotary evaporation devices and does not cover all possible procedures that may be applicable to this topic.

1.3?The accuracy of this guide depends very much on the representative nature of the oil sample used. Certain oils can have different properties depending on their chemical contents at the time a sample is taken.

1.4?UnitsThe values stated in SI units are to be regarded as the standard. No other units of measurement are included in this standard.

1.5?This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.6?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.