ASTM F3613-22

5.1?The significance of the information to be recorded in a test report allows for exoskeleton safety and performance to be contextualized with the exoskeleton fit to the user. Exoskeleton tests can also be replicated across similar or different exoskeletons by using this practice to record the exoskeleton fit to the user for a test in a standardized way.

5.2?Limitations of the practice are that not all exoskeletons have the same connections to the body and fit to all users, and therefore, fit to the user may change the exoskeleton capabilities. For example, as users vary in size, shape, gender, etc., an exoskeleton that is fit to one user may allow an increase or decrease in torque applied to the arms, legs, etc. as compared to another user, especially users at the upper and lower limits of manufacturer-suggested exoskeleton sizing. Another example is that an exoskeleton that is not fit properly to a user may be uncomfortable, and as a result the user may not perform tasks as long, as fast, as strong/delicately, or many other possible outcomes.

5.3?It is expected that all exoskeleton tests require the exoskeleton to be fit properly to the user according to manufacturer specifications. However, as testing exoskeletons can vary, so can fit to the user, and variations in fit may also be tested. For example, a test may be performed with the exoskeleton not fit properly to the users legs (for example, longer fit on shorter legs) to evaluate performance changes when the task requires the user to stand on their toes. Should exoskeleton tests be performed with the exoskeleton not fit properly to the user, the test requestor should verify with the manufacturer that the exoskeleton will not harm the user as a result of a bad fit, and provide this information to the test administrator to record on the test report.

5.4?Additional fit and measurement information may be found in Terminology D5219, Practice E3003, and Practice F1731.

1.1?This practice describes a means to record the exoskeleton fit to the user when testing. The practice provides a method for recording exoskeleton: alignment to the user, component distances from the body, sizing, and subjective comfort using a standard recording method.

1.2?This practice is intended to be used with other exoskeleton test methods and practices to provide a clear representation of the exoskeleton fit to the user measured along body planes; provides a basis for comparison of the test circumstances across different exoskeletons or tests, or both; and allows a test to be recreated.

1.3?The values stated in SI units are to be regarded as the standard. The values given in parentheses are not precise mathematical conversions to imperial units. They are close approximate equivalents for the purpose of specifying exoskeleton characteristics while maintaining repeatability and reproducibility of the test method results. These values given in parentheses are provided for information only and are not considered standard.

1.4?This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.5?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.