ASTM F3327-18

5.1 The significance of the information to be recorded in a test report allows for A-UGV performance to be contextualized with A-UGV configuration.

5.2 Limitations of the practice are that not all A-UGVs have the same capabilities or configuration parameters. For example, for capabilities, a vehicle that remaps during navigation versus another vehicle that uses a static map may behave differently in repeated runs of an obstacle avoidance test. For configuration, a vehicle that remaps during navigation may have varying times that obstacles remain in the map for test recreation.

5.3 The environment map used by the A-UGV, developed through localization including any landmarks, shall be saved as used on the A-UGV and should be saved and provided as a human-readable layout on or off the A-UGV (see Appendix X1 showing a sample layout drawing).

5.4 The main A-UGV hardware parameters shall be recorded as follows:

5.5 The main A-UGV software parameters shall be recorded as follows:

5.6 The context for the test shall be recorded by providing detailed answers to the following questions:

5.7 Higher-level categories of A-UGV capabilities shall be recorded as follows:

1.1 This practice describes a means to record the A-UGV configuration when testing. The practice provides a method for recording A-UGV hardware and software control parameters and describes high-level capabilities, such as used for A-UGV safety and navigation.

1.2 This practice: contextualizes the A-UGV configuration during a test, including the identification and adjustment of main configuration parameters; provides the proper context for test results; provides a basis for comparison of the test circumstances across different vehicles or tests, or both; and allows a test to be recreated.

1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are not precise mathematical conversions to imperial units. They are close approximate equivalents for the purpose of specifying A-UGV characteristics while maintaining repeatability and reproducibility of the test method results. These values given in parentheses are provided for information only and are not considered standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.