Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Practice to Evaluate the Effect of Dynamic Rolling Load over Resilient Floor Covering System
Automaticky preložený názov:
Štandardné Prax na vyhodnotenie dopadu Dynamic Rolling zaťaženie cez elastické podlahové krytiny systému
NORMA vydaná dňa 1.5.2015
Označenie normy: ASTM F2753-10(2015)
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.5.2015
Kód tovaru: NS-610705
Počet strán: 3
Približná hmotnosť: 9 g (0.02 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
dynamic rolling load, resilient floor covering, rolling load simulator, wheel path,, ICS Number Code 97.150 (Non-textile floor coverings)
Significance and Use | ||||
4.1 The effect of dynamic rolling load over resilient floor covering system is important since the resistance reflects the ability of a resilient floor covering system to properly perform under specific use or condition. 4.2 Excessive rolling load over an installed resilient floor covering may cause floor covering system failures such as bond failure, delamination, and finish or coating deteriorations. 4.3 The effect of dynamic rolling load shall be measured by qualitative evaluation comparing the tested assembly with a standard assembly. |
||||
1. Scope | ||||
1.1 This practice covers the determination of the effect of dynamic rolling load over a resilient floor covering. 1.2 This practice is intended to be used by resilient, adhesive and underlayment manufacturers to measure the impact of a dynamic rolling load over a specific product or a combination of products. 1.3 This practice may be used to evaluate the performance of joints (sealed or welded) in the resilient floor covering. 1.4 This practice may be used to aid in the diagnosis of a specific assembly performance and provide comparative evaluation. 1.5 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||
2. Referenced Documents | ||||
|
Chcete mať istotu, že používate len platné technické normy?
Ponúkame Vám riešenie, ktoré Vám zaistí mesačný prehľad o aktuálnosti noriem, ktoré používate.
Chcete vedieť viac informácií ? Pozrite sa na túto stránku.
Posledná aktualizácia: 2024-09-08 (Počet položiek: 2 346 217)
© Copyright 2024 NORMSERVIS s.r.o.