Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Classification for Specifying Silicone Adhesives and Sealants for Transportation Applications
Automaticky preložený názov:
Štandardná klasifikácia pre určenie Silikónové lepidiel a tmelov pre dopravné aplikácie
NORMA vydaná dňa 1.5.2011
Označenie normy: ASTM F2468-05(2011)
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.5.2011
Kód tovaru: NS-53943
Počet strán: 5
Približná hmotnosť: 15 g (0.03 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
Sealants, Silicone, Transportation applications, Adhesives, ICS Number Code 55.040 (Packaging materials and accessories), 71.100.55 (Silicones)
Significance and Use | ||||||||||||||||||||||||||||||||||||||||||||||
The purpose of this classification system is to provide a method of adequately identifying silicone adhesives and sealants through the use of a line call-out designation. This classification system was designed to permit the addition of property values for future silicone adhesives and sealants. |
||||||||||||||||||||||||||||||||||||||||||||||
1. Scope | ||||||||||||||||||||||||||||||||||||||||||||||
1.1 This classification covers silicone adhesives and sealants intended for but not limited to sealing and retaining metallic and nonmetallic component assemblies in transportation applications. The materials cure to an elastomeric state by their specified cure system and mechanism. Note 1—The classification system may serve many of the needs of industries using silicone materials. This classification is subject to revision, as the need requires; therefore, the latest revision should always be used. 1.2 This classification is intended to be a means of classifying silicone materials. It is not intended for engineering design purposes. 1.3 It is not the intent of this classification to include pressure-sensitive or hot-melt adhesives. 1.4 In all cases in which the provisions of this classification system would conflict with the referenced ASTM standard for a particular method, the latter shall take precedence. 1.5 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.6 The following safety hazards caveat pertains only to the test methods portion, Section 7, of this classification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||||||||||||||||||||||||||||||||||||||||
2. Referenced Documents | ||||||||||||||||||||||||||||||||||||||||||||||
|
Historická
1.6.2009
Historická
15.10.2012
Historická
1.7.2011
Historická
1.7.2011
Historická
1.1.2012
Posledná aktualizácia: 2024-11-04 (Počet položiek: 2 209 323)
© Copyright 2024 NORMSERVIS s.r.o.