Cookies
Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
ASTM F2440-18
Standard Specification for Indoor Wall/Feature Padding
NORMA vydaná dňa 1.11.2018
Informácie o norme:
Označenie normy: ASTM F2440-18
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.11.2018
Kód tovaru: NS-909281
Počet strán: 2
Približná hmotnosť: 6 g (0.01 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Kategórie - podobné normy:
Anotácia textu normy ASTM F2440-18 :
Keywords:
protective pad, shock absorption pad, wall pad,, ICS Number Code 91.180 (Interior finishing)
Doplňujúce informácie
| Significance and Use | ||
|
5.1 The padding shall be constructed to yield the values listed in Table 1 throughout the impact area under the conditions of the manufacturer's warranty. 5.2 Special requirements for the padding
shall be subject to purchase agreements. Special requirements shall
never reduce any of the basic requirements listed in this
standard.
5.3 Good manufacturing practices shall be used in the construction and inspection of the padding. |
||
| 1. Scope | ||
|
1.1 This specification covers wall padding and padding for other indoor structures. All padding constructions are included. The intended use of this specification is for the qualification of construction designs and comparison of products. Note 1: This specification was developed due to the numerous
designs in existence and the need to provide a method to determine
if a wall pad meets a minimum level of protection.
Note 2: There is no equivalent ISO standard.
1.2 The values as stated in SI units are to be regarded as the standard. The values in parentheses are given for information only. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||
| 2. Referenced Documents | ||
|
Doporučujeme:
