Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Specification for Mechanical Couplings Used on Polyethylene Conduit, Duct and Innerduct
Automaticky preložený názov:
Štandardné špecifikácie pre mechanických spojovacích zariadení používaných na polyetylénovej rúrky, potrubia a Innerduct
NORMA vydaná dňa 1.3.2009
Označenie normy: ASTM F2176-02(2009)
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.3.2009
Kód tovaru: NS-53081
Počet strán: 3
Približná hmotnosť: 9 g (0.02 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
conduit, duct, innerduct, mechanical fitting, Conduits--specifications, Ducts/duct liners, Innerducts, Mechanical fittings, Polyethylene (PE) pipe--specifications, ICS Number Code 29.120.10 (Conduits for electrical purposes)
1. Scope | ||||||||||
1.1 This specification establishes requirements for material, performance, workmanship and test methods for the qualification of 2 in. and smaller mechanical couplings that connect to DR 15.5 and lower polyethylene conduit, duct and innerduct covered by Specification F 2160. Throughout this standard, “conduit” refers to “conduit, duct or innerduct” manufactured in accordance with Specification F 2160. 1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.3 The couplings covered by this specification are typically designed to join between conduit ends (in-line coupling). The same coupling-to-conduit joint design may be used as a part of other coupling joint designs that telescope, or connect to bulkheads, or other adapter fitting designs. The requirements of this standard apply only to the coupling-to-conduit joint design. The performance requirements of other coupling joint designs are not a part of this standard. 1.4 The following safety hazards caveat pertains only to the test methods portion, Section 9 of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory requirements prior to use. |
||||||||||
2. Referenced Documents | ||||||||||
|
Historická
1.9.2013
Historická
1.11.2013
Historická
1.8.2010
Historická
1.4.2010
Posledná aktualizácia: 2024-12-22 (Počet položiek: 2 217 000)
© Copyright 2024 NORMSERVIS s.r.o.