ASTM F1964-21

5.1?The energy input rate test is used to confirm that the fryer under test is operating in accordance with its nameplate rating.

5.2?Fryer temperature calibration is used to ensure that the fryer being tested is operating at the specified temperature. Temperature calibration also can be used to evaluate and calibrate the thermostat control dial.

5.3?Preheat energy and time can be used by food service operators to manage their restaurants' energy demands, and to estimate the amount of time required for preheating a fryer.

5.4?Idle energy rate and pilot energy rate can be used to estimate energy consumption during noncooking periods.

5.5?Preheat energy, idle energy rate, pilot energy rate, and heavy-load cooking energy rates can be used to estimate the fryer's energy consumption in an actual food service operation.

5.6?Cooking energy efficiency is a direct measurement of fryer efficiency at different loading scenarios. This information can be used by food service operators in the selection of fryers, as well as for the management of a restaurants' energy demands.

5.7?Production capacity is used by food service operators to choose a fryer that matches their food output requirements.

1.1?This test method evaluates the energy consumption and cooking performance of pressure and kettle fryers. The food service operator can use this evaluation to select a fryer and understand its energy efficiency and production capacity.

1.2?This test method is applicable to floor model natural gas and electric pressure fryers.

1.3?The fryer can be evaluated with respect to the following:

1.4?The values stated in inch-pound units are to be regarded as standard. The SI units given in parentheses are for information only.

1.5?This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.6?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.