Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Test Method for Comparison of Rearfoot Motion Control Properties of Running Shoes
Automaticky preložený názov:
Štandardná skúšobná metóda pre porovnanie Motion vlastností bežecké topánky Control rearfoot
NORMA vydaná dňa 1.11.2011
Označenie normy: ASTM F1833-97(2011)
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.11.2011
Kód tovaru: NS-51750
Počet strán: 9
Približná hmotnosť: 27 g (0.06 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
orthoses, pronation, rearfoot motion, running shoe, stability, Athletic footwear, Orthoses, Pronation, Rearfoot motion, Running shoes, Stability--consumer products, ICS Number Code 61.060 (Footwear)
Significance and Use | ||
This test method allows the rearfoot control properties of running shoes or corrective orthoses within shoes to be compared provided they are tested concurrently and under identical conditions. Tests of this type are commonly used in the development and performance testing of running shoes and other in-shoe devices. Careful adherence to the requirements and recommendations of this test shall provide results which can be compared between different laboratories. Note 1—The variance in rearfoot motion due to differences between shoes is generally smaller than the variance between subjects. Direct comparisons between shoes tested in different experiments is therefore not possible. |
||
1. Scope | ||
1.1 This test method covers the measurement of certain angular motions of the lower extremity during running, specifically, the frontal plane projection of the pronation and supination of the lower leg relative to the foot (“rearfoot motion”) and methods by which the effects of different running shoes on rearfoot motion may be compared. 1.2 As used in this test method, footwear may refer to running shoes, corrective shoe inserts (orthoses) or specific combinations of both. The effects of orthoses may vary from shoe to shoe. Therefore, comparisons involving orthoses shall be qualified by the specific style of shoes in which they are tested. 1.3 This test method is limited to the measurement of the two dimensional, frontal plane projection of the relative angular motion between the lower leg and the foot (“rearfoot motion”). It is not a direct measure of pronation or supination, which are three dimensional motions. 1.4 This test method is limited to running motions in which the heel makes first contact with the ground during each step. 1.5 This test method is applicable to measurements of rearfoot motion made while subjects run on a treadmill or while they run overground under controlled conditions. 1.6 The values stated in SI units are to be regarded as the standard. The inch-pound units given in parentheses are for information only. 1.7 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||
2. Referenced Documents | ||
|
Historická
15.1.2009
Historická
15.5.2012
Historická
1.5.2013
Historická
1.6.2014
Historická
1.11.2011
Historická
1.11.2011
Posledná aktualizácia: 2024-11-22 (Počet položiek: 2 206 568)
© Copyright 2024 NORMSERVIS s.r.o.