Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Practice for Calibrating Oil Spill Dispersant Application Equipment Boom and Nozzle Systems
NORMA vydaná dňa 1.3.2022
Označenie normy: ASTM F1460/F1460M-18(2022)
Dátum vydania normy: 1.3.2022
Kód tovaru: NS-1051430
Počet strán: 3
Približná hmotnosť: 9 g (0.02 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
boom and nozzles, dispersant application, dispersant spray equipment, dispersants, oil spill chemicals, oil spill dispersants, oil spill treating agents ,, ICS Number Code 21.260 (Lubrication systems)
Significance and Use |
3.1?This practice will enable calibration of oil spill dispersant application equipment and ensure a desired dosage and uniformity across the swath width. 3.2?The data provided by the methods described herein will permit the preparation of a chart relating delivery rate with application vehicle speed, flow meter reading or pump setting so that in actual application, the desired dosage will be achieved. 3.3?This practice will ensure that a dispersant application system is functional, capable of delivering a specified dosage, and that major components are operational. This will also ensure that the unit is functioning according to design specifications as detailed in Guide F1413. |
1. Scope |
1.1?This practice covers uniform procedures for determining and reporting the dosage rate of oil spill dispersant application equipment. 1.2?This practice is applicable to spray systems employing booms and nozzles and is not fully applicable to other systems such as fire monitors, sonic distributors, or fan-spray guns. 1.3?This practice is applicable to systems for use on ships, boats, helicopters, or airplanes. 1.4?This practice is one of four related to dispersant application systems using booms and nozzles. One is on design, one on calibration, one on deposition, and one on the use of the systems. Familiarity with all four standards is recommended. 1.5?The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined. 1.6?This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.7?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
Poskytovanie aktuálnych informácií o legislatívnych predpisoch vyhlásených v Zbierke zákonov od roku 1945.
Aktualizácia 2x v mesiaci !
Chcete vedieť viac informácii ? Pozrite sa na túto stránku.
Posledná aktualizácia: 2024-11-22 (Počet položiek: 2 206 568)
© Copyright 2024 NORMSERVIS s.r.o.