Cookies
Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
ASTM F1458-98
Standard Test Method for Measurement of Cut Resistance to Chain Saw of Foot Protective Devices
Automaticky preložený názov:
Štandardná skúšobná metóda pre meranie odporu Cut , aby reťazová píla nohy ochranných zariadení
NORMA vydaná dňa 10.10.1998
Informácie o norme:
Označenie normy: ASTM F1458-98
Poznámka: NEPLATNÁ
Dátum vydania normy: 10.10.1998
Kód tovaru: NS-50372
Počet strán: 9
Približná hmotnosť: 27 g (0.06 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Anotácia textu normy ASTM F1458-98 :
Keywords:
Abrasion resistance-copy materials/printed products, Copy materials/products-office, Reflectometer, Smudge, Sutherland ink rub tester, abrasion/smudge resistance-images produced on office products, by, Sutherland test,, Chain saw, Cut resistance, Foot protective devices, Gaiters, Liners, Performance-protective clothing/materials applications, cut resistance of foot protective devices-chain saw, test, ICS Number Code 13.340.10 (Protective clothing)
Doplňujúce informácie
| 1. Scope | ||||
|
1.1 This test method measures cut resistance of foot protective devices which are designed to protect the foot when operating a chain saw. 1.2 This test method may be used to test for compliance to minimum performance requirements in established safety standards. 1.2.1 By agreement between the purchaser and the supplier, or as required by established safety standards, this test method can be used to determine any one or all of the following: (1) threshold stopping speed (2) pass/fail at specified chain speed, or (3) cut through time. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. 1.4 The values stated in SI units or in other units shall be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system must be used independently of the other, without combining values in any way. |
||||
| 2. Referenced Documents | ||||
|
Odporúčame:
Aktualizácia technických noriem
Chcete mať istotu, že používate len platné technické normy?
Ponúkame Vám riešenie, ktoré Vám zaistí mesačný prehľad o aktuálnosti noriem, ktoré používate.
Chcete vedieť viac informácií ? Pozrite sa na túto stránku.
