Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Test Method for Linear Dimensional Stability of a Gasket Material to Moisture
NORMA vydaná dňa 1.4.2023
Označenie normy: ASTM F1087-02(2023)
Dátum vydania normy: 1.4.2023
Kód tovaru: NS-1141612
Počet strán: 2
Približná hmotnosť: 6 g (0.01 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
linear dimensional stability, moisture, thickness,, ICS Number Code 21.140 (Seals, glands)
Significance and Use |
3.1?Gasket materials undergo several processing steps from point of manufacture to installation in a flange. Many applications require close control of dimensional change. An accurate test method for determining the relative stability of various materials is needed for design and quality assurance purposes. This test method is useful towards that end. It simulates the extreme storage conditions that a material may undergo prior to installation. Samples are allowed unrestricted expansion or contraction, and so this test method should not be used to predict behavior clamped in a flange or other applications, or during specific processing steps. 3.2?This test method measures linear change, and may need to be modified if the test specimen is not flat, homogeneous, or free of voids. |
1. Scope |
1.1?This test method covers a procedure to determine the stability of a gasket material to linear dimensional change due to hygroscopic expansion and contraction. It subjects a sample to extremes, that is, oven drying and complete immersion in water, that have shown good correlation to low and high relative humidities.2 1.2?The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only. 1.3?This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
Chcete mať istotu, že používate len platné technické normy?
Ponúkame Vám riešenie, ktoré Vám zaistí mesačný prehľad o aktuálnosti noriem, ktoré používate.
Chcete vedieť viac informácií ? Pozrite sa na túto stránku.
Posledná aktualizácia: 2024-12-23 (Počet položiek: 2 217 157)
© Copyright 2024 NORMSERVIS s.r.o.