Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Test Method for Determining Volume Fraction by Systematic Manual Point Count
Automaticky preložený názov:
Štandardná skúšobná metóda pre stanovenie objem frakcie: Systematický Manuálna gróf Point
NORMA vydaná dňa 1.10.2011
Označenie normy: ASTM E562-11
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.10.2011
Kód tovaru: NS-47217
Počet strán: 7
Približná hmotnosť: 21 g (0.05 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
Metallographic analysis/inspection, Point count, Systematic manual point count, Volume change, ICS Number Code 77.040.99 (Other methods of testing metals)
Significance and Use | ||||||||||
This test method is based upon the stereological principle that a grid with a number of regularly arrayed points, when systematically placed over an image of a two-dimensional section through the microstructure, can provide, after a representative number of placements on different fields, an unbiased statistical estimation of the volume fraction of an identifiable constituent or phase (1, 2, 3). This test method has been described (4) as being superior to other manual methods with regard to effort, bias, and simplicity. Any number of clearly distinguishable constituents or phases within a microstructure (or macrostructure) can be counted using the method. Thus, the method can be applied to any type of solid material from which adequate two-dimensional sections can be prepared and observed. A condensed step-by-step guide for using the method is given in Annex A1. |
||||||||||
1. Scope | ||||||||||
1.1 This test method describes a systematic manual point counting procedure for statistically estimating the volume fraction of an identifiable constituent or phase from sections through the microstructure by means of a point grid. 1.2 The use of automatic image analysis to determine the volume fraction of constituents is described in Practice E1245. 1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||||
2. Referenced Documents | ||||||||||
|
Historická
1.10.2011
Historická
1.3.2014
Historická
1.5.2013
Historická
1.10.2007
Historická
15.3.2007
Historická
1.10.2008
Chcete mať istotu o platnosti využívaných predpisov?
Ponúkame Vám riešenie, aby ste mohli používať stále platné (aktuálne) legislatívne predpisy
Chcete vedieť viac informácií ? Pozrite sa na túto stránku.
Posledná aktualizácia: 2024-11-22 (Počet položiek: 2 206 568)
© Copyright 2024 NORMSERVIS s.r.o.