Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Test Methods for Leaks Using the Mass Spectrometer Leak Detector or Residual Gas Analyzer in the Tracer Probe Mode
Automaticky preložený názov:
Štandardné testovacie metódy pre tesnosť hmotnostného spektrometra netesností alebo zvyškový plyn Analyzer v Tracer režime Probe
NORMA vydaná dňa 10.7.2000
Označenie normy: ASTM E498-95(2000)
Poznámka: NEPLATNÁ
Dátum vydania normy: 10.7.2000
Kód tovaru: NS-46988
Počet strán: 4
Približná hmotnosť: 12 g (0.03 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
Bell jar leak test, Bomb mass spectrometer leak test, Helium leak testing, Leak testing, Leak testing-mass spectrometer leak detector (MSLD), Mass spectrometer leak detector (MSLD), Mass spectrometry, Probe methods, Residual gas analyzer (RGA), Tracer probe mode, Vacuum testing, leak detection-using the mass spectrometer leak detector/residual gas, analyzer in the tracer probe mode, test,, Sealed object mass spectrometer leak test
1. Scope | ||||
1.1 These test methods cover procedures for testing and locating the sources of gas leaking at the rate of 4.5 X 10 -14 mol/s (1 X 10 -9 Std cm3/s) or greater. The test may be conducted on any object to be tested that can be evacuated and to the other side of which helium or other tracer gas may be applied. 1.2 Three test methods are described: 1.2.1 Test Method A -For the object under test capable of being evacuated, but having no inherent pumping capability. 1.2.2 Test Method B -For the object under test with integral pumping capability. 1.2.3 Test Method C -For the object under test as in Test Method B, in which the vacuum pumps of the object under test replace those normally used in the leak detector. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. A specific hazard statement can be found in 19.2. |
||||
2. Referenced Documents | ||||
|
Posledná aktualizácia: 2024-11-01 (Počet položiek: 2 208 817)
© Copyright 2024 NORMSERVIS s.r.o.