Standard Practice for Measuring and Calculating Building Loss Features That Take Up Floor Area in Buildings
NORMA vydaná dňa 1.10.2017
Označenie normy: ASTM E2619/E2619M-17
Dátum vydania normy: 1.10.2017
Kód tovaru: NS-800244
Počet strán: 11
Približná hmotnosť: 33 g (0.07 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
actual loss, area measurement, building, building elements, building feature, building loss factor, capability, column size, effective loss, exterior gross area, facility, facility occupants, feature, floor area, floor area measurement, floor load, function, interior encroachment, major vertical penetrations, office, performance, perimeter encroachment, rating, rating scale, requirements, restricted area, service area, serviceability,, ICS Number Code 91.010.30 (Technical aspects)
|Significance and Use|
4.1 Use this practice to identify and measure the amount of actual and effective floor area that will be unavailable to occupants for the placement of people’s workplaces, furniture, and equipment or for circulation.
4.2 Findings from use of this practice are intended for optional inclusion with reports of floor area measured in accordance with Practice or in accordance with ANSI/BOMA Z65.1–1996.
Note 1: The choice between using Practice or ANSI/BOMA Z65.1–1996 as the basis for measurement depends on the objectives of the analysis. Practice is oriented to the traditional interests of design professionals and would be particularly suitable for single-tenant buildings whereas some categories of space measured by ANSI/BOMA Z65.1–1996 are oriented to the leasing of multi-tenant buildings by real estate professionals.
4.3 this practice is not intended for use for regulatory purposes, nor for fire hazard assessment, nor for fire risk assessment.
1.1 This practice specifies how to measure certain characteristics of a building, known as building loss features, inside the exterior gross area of a floor and how to calculate the amount of actual and effective floor area that will be not be available for the placement of people’s workplaces, furniture, equipment, or for circulation, if using standard furnishings and orthogonal furniture systems.
1.2 This practice can be used to specify a performance requirement to limit the amount of floor area that may be taken up by building loss features.
1.3 This practice can be used to assess how well a design(s) for an office facility meets a performance requirement regarding floor area.
1.4 This practice can be used to assess how well a constructed office building has met a performance requirement regarding floor area.
1.5 This practice is not intended for and not suitable for use for regulatory purposes, fire hazard assessment, and fire risk assessment.
1.6 Users of this practice should recognize that, in some situations, the amount of certain 1.7 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.8 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.9 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
|2. Referenced Documents|
Posledná aktualizácia: 2019-08-19 (Počet položiek: 2 262 021)
© Copyright 2019 NORMSERVIS s.r.o.