Cookies
Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
ASTM E2561-07a(2018)
Standard Practice for the Installation of Inductive Loop Detectors (Includes all amendments And changes 11/12/2024).
NORMA vydaná dňa 1.9.2018
Informácie o norme:
Označenie normy: ASTM E2561-07a(2018)
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.9.2018
Kód tovaru: NS-897725
Počet strán: 14
Približná hmotnosť: 42 g (0.09 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Kategórie - podobné normy:
Anotácia textu normy ASTM E2561-07a(2018) :
Keywords:
grounding, inductive loop, inductive loop detector, lead-in wire, lead-in cable, loop wire, sealant, splice, wire loop,, ICS Number Code 93.080.30 (Road equipment and installations)
Doplňujúce informácie
| Significance and Use |
|
4.1 This practice provides a method for the in-road installation of an inductive loop detector that consists of wire loops, lead-in wires, and lead-in cable. The practice is intended for installing wires in saw cuts made in the roadway surface and not for installing preformed loops that may be encased in a protective enclosure such as plastic conduit. Typical components of an inductive loop detector system are illustrated in Fig. 1. Modern inductive loop detector electronic units are capable of detecting vehicles even if the wire loop is laid on reinforcing steel before concrete is placed. FIG. 1 Inductive Loop Detector System (Notional) 1.1 This practice describes the recommended procedure for installing inductive loop detectors in sawed slots in roadway pavement for use as a traffic monitoring device or to actuate traffic control devices such as a traffic signal. Although the practice is not intended for installing preformed loops, the practice does contain information of value for this type of loop, such as recommendations for the number of turns of loop wire, number and direction of twists in the lead-in wire and cable, splice location (if needed), and grounding options. 1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
Odporúčame:
Aktualizácia zákonov
Chcete mať istotu o platnosti využívaných predpisov?
Ponúkame Vám riešenie, aby ste mohli používať stále platné (aktuálne) legislatívne predpisy
Chcete vedieť viac informácií ? Pozrite sa na túto stránku.
