Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Practice for Sampling Copper and Copper Alloys for the Determination of Chemical Composition (Withdrawn 2023)
Automaticky preložený názov:
Štandardná prax pre vzorkovanie medi a zliatin medi pre stanovenie chemického zloženia
NORMA vydaná dňa 1.12.2014
Označenie normy: ASTM E255-07(2014)
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.12.2014
Kód tovaru: NS-586954
Počet strán: 5
Približná hmotnosť: 15 g (0.03 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
copper, copper alloys, sampling ,, ICS Number Code 77.040.30 (Chemical analysis of metals),77.120.30 (Copper and copper alloys)
Significance and Use | ||
4.1 This practice is intended primarily for the sampling of copper and copper alloys for compliance with compositional specification requirements. 4.2 The selection of correct test pieces and the preparation of a representative sample from such test pieces are necessary prerequisites to every analysis. The analytical results will be of little value unless the sample represents the average composition of the material from which it was prepared. |
||
1. Scope | ||
1.1 This practice describes the sampling of copper (except electrolytic cathode) and copper alloys in either cast or wrought form for the determination of composition. 1.2 Cast products may be in the form of cake, billet, wire bar, ingot, ingot bar, or casting. 1.3 Wrought products may be in the form of flat, pipe, tube, rod, bar, shape, or forging. 1.4 This practice is not intended to supersede or replace existing specification requirements for the sampling of a particular material. 1.5 The values stated in inch-pound units are to be regarded as the standard. The values in parentheses are given for information only. 1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. A specific precautionary statement appears in Appendix X4. |
||
2. Referenced Documents | ||
|
Chcete mať istotu o platnosti využívaných predpisov?
Ponúkame Vám riešenie, aby ste mohli používať stále platné (aktuálne) legislatívne predpisy
Chcete vedieť viac informácií ? Pozrite sa na túto stránku.
Posledná aktualizácia: 2024-03-25 (Počet položiek: 2 885 931)
© Copyright 2024 NORMSERVIS s.r.o.