Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Specification for Portable Air Heaters Used at Personnel Decontamination Stations and Shelters
NORMA vydaná dňa 1.12.2022
Označenie normy: ASTM E2543-08(2022)
Dátum vydania normy: 1.12.2022
Kód tovaru: NS-1099220
Počet strán: 3
Približná hmotnosť: 9 g (0.02 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
This specification is used to standardize the portable air heaters used on personnel decontamination lines to insure the heaters provide sufficient heated air for personnel comfort before, during, and after the decontamination for as long as they are needed during the emergency. The heater materials of construction shall be easily cleaned of surface mud and grime with no degradation of the unit’s ability to perform its function. The preferred fuels for the heater section of the portable air heater are diesel fuel, gasoline, or bottled propane gas. Measurement of the air heater unit’s air flow and input and output temperatures shall be performed.
Keywords:
decontamination, shelter, warm air,, ICS Number Code 13.200 (Accident and disaster control),97.100.01 (Domestic, commercial and industrial heating appliances in general)
Significance and Use | ||||||||
11.1?The use of these acceptance tests will insure that organizations buying portable heaters will be assured the heaters meet certain performance requirements. |
||||||||
1. Scope | ||||||||
1.1?This specification is used to standardize the portable air heaters used on personnel decontamination lines to insure the heaters provide sufficient heated air for personnel comfort before, during, and after the decontamination for as long as they are needed during the emergency. Note 1:?These heaters are not intended to be used for the
decontamination for any other surface or material. Also, these
heaters are intended to be portable and easy to use by first
responders during a chemical, biological, radiological, nuclear,
and explosive (CBRNE) event.
1.2?This specification contains a specification section and a test methods section so users need to refer to the section applicable to their needs when using this standard specification. 1.3?The values stated in SI units are to be regarded as standard. The values given in parentheses are for information only. Note 2:?The U.S. first responder personnel using the equipment
manufactured under this standard are not likely to be familiar with
SI units so English units need to be included as part of the system
documentation and shown on control panels for any equipment sold to
U.S. organizations.
1.4?This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||
2. Referenced Documents | ||||||||
|
Chcete mať istotu o platnosti využívaných predpisov?
Ponúkame Vám riešenie, aby ste mohli používať stále platné (aktuálne) legislatívne predpisy
Chcete vedieť viac informácií ? Pozrite sa na túto stránku.
Posledná aktualizácia: 2024-11-01 (Počet položiek: 2 208 817)
© Copyright 2024 NORMSERVIS s.r.o.