Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Specification for Light Source Products for Inspection of Fluorescent Coatings
Automaticky preložený názov:
Štandard Specification zdroja svetla produkty po inšpekcii Fluorescent Coatings
NORMA vydaná dňa 1.6.2011
Označenie normy: ASTM E2501-11
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.6.2011
Kód tovaru: NS-45444
Počet strán: 3
Približná hmotnosť: 9 g (0.02 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
coating inspection, fluorescent coatings, fluorescent inspection light, Fluorescent coatings, Light source products, ICS Number Code 25.220.01 (Surface treatment and coating in general), 29.140.40 (Luminaries)
Significance and Use | ||||||||||
Light source products conforming to this specification are intended to be used in conjunction with coatings specially formulated with fluorescent colorants as a system for the visual detection of defects in industrial protective coatings. Visible fluorescence from the coating enhances the contrast of coating irregularities and defects and is produced by excitation of visible-activated fluorescent colorants in the coating. Light source products with defined wavelength and intensity properties are required to produce adequate visible fluorescence for easy visual location of defects. A light source product is considered to consist of a light source component incorporated into an optical, electrical, mechanical, and power supply system that makes it suitable for use in an industrial environment. The entire light source product is subject to this standard. The light source component and any subassemblies of the light source product are not subject to this standard This specification is limited to light source products providing excitation in the range from 400 to 420 nm. |
||||||||||
1. Scope | ||||||||||
1.1 This specification provides the requirements for light source products intended for excitation of fluorescent materials used as a system for detection of defects in industrial coatings. This includes the examination of both longer wavelength fluorescing primer coatings as well as non-fluorescent top coatings. 1.2 This specification establishes the radiometric requirements of the light source product in terms of required wavelength range and minimum irradiance. 1.3 This specification establishes safety requirements for the light source product necessary to ensure the product will not pose a threat to visual health. 1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||||
2. Referenced Documents | ||||||||||
|
Historická
1.12.2010
Historická
1.6.2013
Historická
1.6.2011
Historická
1.11.2013
Historická
1.11.2012
Historická
1.2.2013
Poskytovanie aktuálnych informácií o legislatívnych predpisoch vyhlásených v Zbierke zákonov od roku 1945.
Aktualizácia 2x v mesiaci !
Chcete vedieť viac informácii ? Pozrite sa na túto stránku.
Posledná aktualizácia: 2024-11-04 (Počet položiek: 2 209 323)
© Copyright 2024 NORMSERVIS s.r.o.