Cookies
Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
ASTM E2113-04
Standard Test Method for Length Change Calibration of Thermomechanical Analyzers
Automaticky preložený názov:
Štandardná testovacia metóda pre Dĺžka Zmena Kalibrácia termomechanickej Analyzátory
NORMA vydaná dňa 1.10.2004
Informácie o norme:
Označenie normy: ASTM E2113-04
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.10.2004
Kód tovaru: NS-44342
Počet strán: 5
Približná hmotnosť: 15 g (0.03 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Anotácia textu normy ASTM E2113-04 :
Keywords:
calibration, coefficient of thermal expansion, deflection, expansion, expansivity, thermal analysis, thermal expansion, thermomechanical analyzer, ICS Number Code 83.080.01 (Plastics in general)
Doplňujúce informácie
| Significance and Use | ||||||||||||
|
Performance verification or calibration is essential to the accurate determination of quantitative dimension change measurements. This method may be used for instrument performance validation, regulatory compliance, research and development and quality assurance purposes. |
||||||||||||
| 1. Scope | ||||||||||||
|
1.1 This method describes calibration of the length change (deflection) measurement or thermal expansion of thermomechanical analyzers (TMA) within the temperature range from -150 to 1000 C using the thermal expansion of a suitable reference material. 1.2 SI values are the standard. 1.3 This method differs from ISO standard 11359-1 by providing an alternative calibration procedure. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of whoever uses this standard to consult and establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||||||
| 2. Referenced Documents | ||||||||||||
|
Doporučujeme:
