Cookies
Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
ASTM E2070-00
Standard Test Method for Kinetic Parameters by Differential Scanning Calorimetry Using Isothermal Methods
Automaticky preložený názov:
Štandardná skúšobná metóda pre kinetické parametre diferenčnej skenovacej kalorimetrie Použitie izotermickej metódy
NORMA vydaná dňa 10.3.2000
Informácie o norme:
Označenie normy: ASTM E2070-00
Poznámka: NEPLATNÁ
Dátum vydania normy: 10.3.2000
Kód tovaru: NS-44184
Počet strán: 9
Približná hmotnosť: 27 g (0.06 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Anotácia textu normy ASTM E2070-00 :
Keywords:
activation energy, autocatalytic reactions, crystallization reactions, differential scanning calorimetry (DSC), frequency factor, kinetics, nth order reactions, pre-exponential factor, reactions, thermal analysis, thermoset cure, ICS Number Code 17.200.10 (Heat. Calorimetry)
Doplňujúce informácie
| 1. Scope | ||||||||||||||||||||||||||||||||||||
|
1.1 Test Method A determines kinetic parameters for activation energy, frequency factor and reaction order using differential scanning calorimetry from a series of isothermal experiments over a small ( 10 K) temperature range. This treatment is applicable to low nth order reactions and to autocatalyzed reactions such as thermoset curing or pyrotechnic reactions and crystallization transformations in the temperature range from 300 to 900 K (30 to 630 C). This test method is applicable only to these types of exothermic reactions when the thermal curves do not exhibit shoulders, discontinuities or shifts in baseline. 1.2 Test Method B also determines the activation energy of a set of time-to-event and isothermal temperature data generated by this or other procedures. 1.3 Electronic instrumentation or automated data analysis systems or treatments equivalent to this test method may be used. Note 1Since all electronic data systems are not equivalent, the user must verify the applicability of the treatment to this method. 1.4 SI units are the standard. 1.5 This test method is similar but not equivalent to ISO 11357, Part 5, and provides more information than the ISO standard. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific precautionary statements are given in Section . |
||||||||||||||||||||||||||||||||||||
| 2. Referenced Documents | ||||||||||||||||||||||||||||||||||||
|
Doporučujeme:
