Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Practice for Atmospheric Leaks Using a Thermal Conductivity Leak Detector
Automaticky preložený názov:
Štandardná prax pre atmosférické tesnosť tepelnú vodivosti netesností
NORMA vydaná dňa 1.7.2011
Označenie normy: ASTM E2024/E2024M-11
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.7.2011
Kód tovaru: NS-44005
Počet strán: 3
Približná hmotnosť: 9 g (0.02 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
conductivity leak test, leak testing, sensitive leak test, thermal conductivity leak test, Atmospheric analysis, Atmospheric leaks, Thermal conductivity detectors (TCD, ICS Number Code 19.100 (Non-destructive testing)
Significance and Use | ||||||||
These test methods are useful for locating and estimating the size of pressurized gas leaks, either as quality control tests or as field inspection procedures. Also, they are valuable as pretests before other more time consuming and more sensitive leak tests are employed. These test methods are semi-quantitative techniques used to locate leaks but cannot be used to quantify except for approximation. These test methods may be used in an accept-reject test mode. |
||||||||
1. Scope | ||||||||
1.1 This practice covers procedures for detecting the sources of gas leaking at the rate of 1 × 10–5 Pa m3/s (1 × 10–4 standard cm3/s) or greater. The tests may be conducted on any object that can be pressurized with a tracer gas that is detectable by a thermal conductivity detector. The test sensitivity will vary widely depending on the tracer gas used. 1.2 Units—The values stated in either SI or std-cc/sec units are to be regarded separately as standard. The values stated in each system may not be exact equivalents: therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||
2. Referenced Documents | ||||||||
|
Historická
1.6.2014
Historická
1.12.2013
Historická
1.6.2009
Historická
1.12.2013
Historická
1.6.2010
Historická
1.6.2010
Posledná aktualizácia: 2024-12-22 (Počet položiek: 2 217 000)
© Copyright 2024 NORMSERVIS s.r.o.