ASTM E1757-19

4.1 Preparation Method A—Method suitable for the preparation of large quantities (>20 g) of field collected samples into a form appropriate for compositional analysis. Woody samples must first be available as chips of a nominal 5 by 5 by 0.6 cm (2 by 2 by ¹/₄ in.) or less and twigs not exceeding 0.6 cm (¹/₄ in.) diameter. Herbaceous materials may be processed as whole straw. It is recommended that wastepaper should be shredded into pieces less then 1 cm (¹/₂ in.) wide. Furthermore, it is recommended that twigs, straw, and wastepaper should not exceed 61 cm (24 in.) in length to facilitate handling.

4.2 Preparation Methods B and C—Methods are suitable for very moist feedstocks, samples that would not be stable during prolonged exposure to ambient conditions, or for drying materials when room conditions deviate from the ambient conditions described in 3.1.1. These test methods are also suitable for handling small samples of biomass (<20 g). The drying step is done in a convection oven at 45 °C (Test Method B) or by lyophilization (Test Method C).

4.3 Preparation Methods A, B, and C are not intended for materials that will already pass through a 20 mesh sieve or that cannot be dried by the described methods to a total solids content of greater than 85 %, based on an oven dried weight.

4.4 Preparation Method A will separate the milled material into two fractions, a −20/+80 mesh fraction and a −80 mesh fraction.

4.5 Preparation Method D—Method suitable for cereal grains, cereal grain fermentation mash, cereal grain fermentation beer, and cereal grain fermentation residues that are generally stable.

4.6 Preparation Method E—Method suitable for cereal grains, cereal grain fermentation mash, cereal grain fermentation beer, and cereal grain fermentation residues that are biologically or enzymatically active.

1.1 This practice covers a reproducible way to convert hardwoods, softwoods, herbaceous materials (such as switchgrass and sericea), agricultural residues (such as corn stover, wheat straw, and bagasse), wastepaper (such as office waste, boxboard, and newsprint), cellulosic feedstocks pretreated to improve suitability for fermentation, cereal grains, cereal grain fermentation mash, cereal grain fermentation beer, and fermentation residues into a uniform material suitable for compositional analysis. This practice is intended for samples that need to be dried prior to analysis.

1.2 Milling and sieving actions both produce large amounts of dust. This dust can be a nuisance hazard and irritant. Use appropriate respiratory protection as needed. If excessive amounts of dust are allowed to become airborne a potential explosion hazard is possible. Provide appropriate dust control measures as needed.

1.3 The values stated in SI units are to be regarded as standard. The values given in parentheses after SI units are provided for information only and are not considered standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.