ASTM E1645-01(2007)

Paint in buildings and related structures needs to be monitored for lead content in order to determine the potential lead hazard. Hence, effective and efficient methods are required for the preparation of paint samples that may contain lead.

This practice may be used for the digestion of paint samples that are collected during various lead-hazard control and risk assessment activities associated with lead abatement in and around buildings and related structures. This practice is also suitable for the digestion of paint samples collected from locations such as commercial buildings.

This practice may be used to prepare samples that have been obtained in order to ensure compliance with laws that govern lead content in paints.

This practice may be used to prepare samples that have been collected for risk assessment purposes.

This practice is intended for use with paint samples that are prepared for subsequent analysis by laboratory-based quantitative analytical methods.

1.1 This practice covers the sample preparation procedures for paint samples that are collected during the assessment, management or control of lead hazards.

1.2 This practice describes the digestion procedures using a hot plate or microwave oven or apparatus for paint samples that are to be analyzed for lead content.

1.3 This practice covers the general considerations for quantitative sample extraction for total recoverable lead in dried paint samples (either bulk paint or paint powder) using hot plate or microwave heating techniques, or both.

1.4 The values stated in SI units are to be regarded as the standard.

1.5 This practice contains notes that are explanatory and not part of the mandatory requirements of the standard.

1.6 This practice is based on two NIOSH Methods, 7082 and 7105, and on an EPA standard operating procedure for lead in paint.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific precautionary statements, see 6.2.4.4 and 7.2.1.