Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Test Method for Decomposition Kinetics by Thermogravimetry Using the Ozawa/Flynn/Wall Method
Automaticky preložený názov:
Štandardná skúšobná metóda pre rozkladu kinetiky tým termogravimetria pomocou Ozawa / Flynn / Wall metódy
NORMA vydaná dňa 1.8.2013
Označenie normy: ASTM E1641-13
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.8.2013
Kód tovaru: NS-42486
Počet strán: 7
Približná hmotnosť: 21 g (0.05 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
activation energy, pre-exponential factor, failure, failure criterion, kinetic parameters, thermal analysis, thermal decomposition, thermogravimetric analysis, ICS Number Code 71.040.40 (Chemical analysis)
Significance and Use | ||||||||||||||||||
5.1 Thermogravimetry provides a rapid method for determining the temperature-decomposition profile of a material. 5.2 This test method can be used for estimating lifetimes of materials, using Test Method E1877 provided that a relationship has been established between the thermal endurance test results and actual lifetime tests. |
||||||||||||||||||
1. Scope | ||||||||||||||||||
1.1 This test method describes the determination of the kinetic parameters, Arrhenius activation energy, and preexponential factor by thermogravimetry, based on the assumption that the decomposition obeys first-order kineticsusing the Ozawa/Flynn/Wall isoconversional method (1).2 1.2 This test method is generally applicable to materials with well-defined decomposition profiles, namely, a smooth, continuous mass change with a single maximum rate. 1.3 This test method is normally applicable to decomposition occurring in the range from 400 to 1300K (nominally 100 to 1000°C). The temperature range may be extended depending on the instrumentation used. 1.4 This method is similar to ISO 11358-2 but differs in its mathematical treatment. 1.5 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||||||||||||
2. Referenced Documents | ||||||||||||||||||
|
Chcete mať istotu, že používate len platné technické normy?
Ponúkame Vám riešenie, ktoré Vám zaistí mesačný prehľad o aktuálnosti noriem, ktoré používate.
Chcete vedieť viac informácií ? Pozrite sa na túto stránku.
Posledná aktualizácia: 2024-11-22 (Počet položiek: 2 206 568)
© Copyright 2024 NORMSERVIS s.r.o.